RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: shadow745
Showing results 1 to 13 of 13
Search took 0.59 seconds.
Replies: 7
Views: 532
Posted By shadow745

Are These Good ESCs?

I have a Novak Cyclone '99 and was wondering if you guys think the Cyclone series are still good speedos. Still capable of competing with the top end speedos offered now? I'd also like to know if any...
07-24-2004, 09:07 AM
Replies: 3
Views: 424
Posted By shadow745

RE: Good ESC???

and your point is????? ESCs are a part of radio equipment!
07-23-2004, 12:03 PM
Replies: 3
Views: 424
Posted By shadow745

Good ESC???

Do any of you guys use a Tekin G-10 Pro? If so, what do you think about it? Thanks for any replies!
Replies: 2
Views: 335
Posted By shadow745

Is The Cyclone Still Awesome?

I have a Novak Cyclone '99 (purple label) that I still run with great results. Do you guys think that this ESC is still a top end speedo? In my opinion the Cyclone series speedos can still compete...
Replies: 4
Views: 440
Posted By shadow745

RE: question on speed controller

The numbers you're describing are to tune the current limiter. Turning the dial to a certain number should limit the current flow to match that number. It is supposed to regulate the current (torque)...
Replies: 2
Views: 410
Posted By shadow745

Factory or Aftermarket Receiver?

I have 3 receivers to choose from, but can't seem to make a decision. I have a 92237 (it came with my Airtronics Caliber 3 PS), a Tekin Chrome and a Novak XXL. Which would you choose? Thanks for any...
Replies: 4
Views: 737
Posted By shadow745

RE: Gear won't "reach"

You're correct about the spur gear change. Increasing the number of teeth on the spur will increase acceleration, but it is a small change that I use to fine tune my ratios. Increasing the size by...
Replies: 4
Views: 737
Posted By shadow745

RE: Gear won't "reach"

You can try using a larger spur gear. It will make a change in gear ratio, but not a significant one.
Replies: 1
Views: 323
Posted By shadow745

Which One Would You Use?

I have a Cyclone '99 with a Pit Wizard, a Tekin G-10 Pro and a Tekin G-12cIII. I have been in this hobby a long time and know that all three of these ESC's are top-of-the-line and either of the three...
Replies: 1
Views: 377
Posted By shadow745

RE: Capacitors

You must use 3 capacitors on any motor that doesn't have them surface mounted. You can pick them up at any Radio Shack. The type that I use are marked 104 or .1. They vary in color and size (all are...
Replies: 10
Views: 745
Posted By shadow745

RE: 50mph??

If I was going to try that I'd start with a 7-8 turn motor, a 7-cell pack and go a few teeth higher on the pinion gear. You must have a good ESC and good connectors or solder joints to handle any...
Replies: 1
Views: 278
Posted By shadow745

Is This A Competitive ESC?

I have an older Tekin G-12cIII speedo. Is this still competitive with the newer ones? Thanks for any replies!
Replies: 0
Views: 281
Posted By shadow745

Tekin ESC Info

I have a Tekin G-10 Pro and can't find many specs on this thing. I have looked at alot of manuals online that are marked "Pro", but they are for the original G-10, not the Pro version. Tekin changed...
Showing results 1 to 13 of 13


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.