RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: Henry_90lx
Showing results 1 to 25 of 64
Search took 0.64 seconds.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-20-2004, 10:39 AM
Replies: 26
Views: 2,532
Posted By Henry_90lx

RE: Ultra Stick setup with 9C

The past tense is because I still fly the plane but progammed it quite a long time ago. As far as your problems I am not sure what to tell ya, lots of folks have used this identical program list...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-15-2004, 08:43 AM
Replies: 28
Views: 3,270
Posted By Henry_90lx

RE: 9CAP setup for crow

miamiflyer,

That is pretty strange, I am not sure where the problem could lie with that one. There is alot of stuff moving that is not even coupled in the mixes. But as for the above list...
Forum: Crash & Rebuild
06-28-2004, 10:47 AM
Replies: 129
Views: 12,015
Posted By Henry_90lx

RE: Have YOU ever shot someone else down?

Maybe the frequency to channel numbers are different where you are??

Here cannel 57 = 72.930

channel 58 = 72.950

and there is not even a channel 74 allocated for air use.

Here is...
Forum: Crash & Rebuild
06-28-2004, 10:34 AM
Replies: 129
Views: 12,015
Posted By Henry_90lx

RE: Have YOU ever shot someone else down?

Then why would Broken have shot him down, Broken said he was on 58 if the heli guy was on 57 Broken would not have shot him down.

Henry
Forum: Crash & Rebuild
06-28-2004, 09:16 AM
Replies: 129
Views: 12,015
Posted By Henry_90lx

RE: Have YOU ever shot someone else down?

The way I read it He was on 58 and had 58 displayed, the heli guy that got shot down was on 58 as well but had 57 displayed.


Henry
Forum: Crash & Rebuild
06-25-2004, 12:40 PM
Replies: 9
Views: 1,108
Posted By Henry_90lx

RE: search plane

That or just put one of those things you put on your key ring that beebs when you whistle. That way you could get out to the general are and listen for the beeb.

Another solution is they make...
Forum: S.P.A.D. Aircraft - Coroplast design
06-21-2004, 10:34 PM
Replies: 2
Views: 407
Posted By Henry_90lx

RE: 2 mm in ST.L mo ?

The only supplier that I have found with decent prices is R&J sign supply but they have no 2mm. The only way I have been able to find it in this area is mail ordering it.

Henry
Forum: Futaba Radios Direct support forum
06-21-2004, 11:33 AM
Replies: 5
Views: 741
Posted By Henry_90lx

RE: 9C questions

I belive the diode you are refering to will not let you discharge thru the radio.

Henry
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-21-2004, 03:27 AM
Replies: 26
Views: 2,532
Posted By Henry_90lx

RE: Ultra Stick setup with 9C

Blackie,

Mix off = off or on depends on where the switch is physicly when setting up the mix

mix on = off see above

mix inh = inh and nothing eles

Henry
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-17-2004, 03:28 PM
Replies: 7
Views: 614
Posted By Henry_90lx

RE: Servo question.

I am sorry, I went and looked up the specs for the HS-5475HB, and the 61 is at 4.8v so if you run it at 6v it will be fine, I had misunderstood and was thinking that 61 was the max output of that...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-17-2004, 12:04 PM
Replies: 26
Views: 2,532
Posted By Henry_90lx

RE: Ultra Stick setup with 9C

You got to have alot of power on. It really adds alot of drag. My landing method usually goes something like this. From way up high, go into a dive crow on, then about 15 feet up I start rotate...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-17-2004, 11:46 AM
Replies: 7
Views: 614
Posted By Henry_90lx

RE: Servo question.

This may be true, I wont argue that. But, even flutter can strip gears and cause the total loss of the airplane. Like I said before it is only my opinion, but I for one will not put things that...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-17-2004, 11:40 AM
Replies: 26
Views: 2,532
Posted By Henry_90lx

RE: Ultra Stick setup with 9C

Yes I have it y'ed in on channel 8. Soon as I build another batt pack I will end up y'ing another on another channel.

Henry
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-17-2004, 11:38 AM
Replies: 26
Views: 2,532
Posted By Henry_90lx

RE: Ultra Stick setup with 9C

I am opposite on the flaps on the slider, I like to use them as spoilers on landing ( helps mask my poor landing skills). I just listen for the beep and I know there centered.

Henry
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-17-2004, 11:15 AM
Replies: 7
Views: 614
Posted By Henry_90lx

RE: Servo question.

If the specs recommend 65 I would not go with something with 61. It is always ok to put something with more power than recommended, but NEVER ok to put something with less power, no sense in saving...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-17-2004, 11:10 AM
Replies: 26
Views: 2,532
Posted By Henry_90lx

RE: Ultra Stick setup with 9C

Thats how mine is set up, dual elevators that is. Here is my channe set up

1 R Ailereon
2 L elevator
3 Throttle
4 Rudder
5 R flap
6 L Aileron
7 L flap
8 R elevator
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-17-2004, 09:57 AM
Replies: 26
Views: 2,532
Posted By Henry_90lx

RE: Ultra Stick setup with 9C

Ok here is my setup mix by mix, works like a champ.


Flapperon:

Mix-Act
(L) (R)
Rate-Ail1>+100 +100
Ail2>+100 +100
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-12-2004, 05:50 PM
Replies: 20
Views: 859
Posted By Henry_90lx

RE: 9C Mixing question

Here is a post I made earlier concerning the programing setup for an ultrastick.

Its about a 1/4 of the way down

This set up works real well.

...
Forum: S.P.A.D. Aircraft - Coroplast design
06-10-2004, 11:28 PM
Replies: 9
Views: 1,954
Posted By Henry_90lx

RE: Paint For Coroplast

Same thing is done when applying window tint. But instead of windex a couple drops of dish detergent into a spray bottle of water. Would the dish detergent work the same as windex in this...
Forum: S.P.A.D. Aircraft - Coroplast design
06-08-2004, 06:12 PM
Replies: 5
Views: 666
Posted By Henry_90lx

RE: Glow Powered Ultra Spad Stick

It has come up the wing is having to be moved back even with the 31. It will work with your glow just shorten the tail a little bit and move the wing back a little.

Henry
Forum: S.P.A.D. Aircraft - Coroplast design
06-08-2004, 06:07 PM
Replies: 15
Views: 6,985
Posted By Henry_90lx

RE: Help with coroplast wing for Original Ugly Stik

I use a standard dubro 12 oz tank for all my 2 1/2 gutter pipe applications.

http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXD719&P=0

Also the hayes slimline work in this application
...
Forum: S.P.A.D. Aircraft - Coroplast design
06-08-2004, 02:33 PM
Replies: 15
Views: 6,985
Posted By Henry_90lx

RE: Help with coroplast wing for Original Ugly Stik

Thats a slightly upsized spad stick with a .90 st onit and a 12 ounce tank
http://www.henrylx.rchomepage.com/Pic/webIMG_3018.JPG

Here is another one with a 31cc gasser and a 12 oz tank It use...
Forum: S.P.A.D. Aircraft - Coroplast design
05-20-2004, 08:33 PM
Replies: 2
Views: 411
Posted By Henry_90lx

RE: Spadworld Down??

I just went back and it is back up. must have been down while RCH was doing the upgrade.

Henry
Forum: S.P.A.D. Aircraft - Coroplast design
05-20-2004, 06:58 PM
Replies: 2
Views: 411
Posted By Henry_90lx

Spadworld Down??

Whenever I bring up the page I get this message:

"Please ensure both the install/ and contrib/ directories are deleted"

anyone else getting the same thing.

Henry
Forum: Futaba Radios Direct support forum
05-19-2004, 08:00 PM
Replies: 13
Views: 1,224
Posted By Henry_90lx

RE: My 9c is glitching out bad

In the end yes. A bit of trouble in the process though. Here is a thread over at spadworld that pretty much explains it all.

http://spadworld.net/viewtopic.php?t=7895&highlight=

Henry
Showing results 1 to 25 of 64
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.