RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 10
1
2
3
Last »
Search: Posts Made By: DaveSR71
Showing results 1 to 25 of 246
Search took 0.64 seconds.
Forum: Control Lines
10-23-2010, 01:19 PM
Replies: 11
Views: 1,981
Posted By DaveSR71

RE: K&B 6.5 What to do with

Shorten up the exhaust duration lower compression and possibly a new disk with milder timing would do the trick.
Kind of a silly expensive way to get a PA engine going......

All though in...
Forum: Control Lines
10-23-2010, 11:21 AM
Replies: 11
Views: 1,981
Posted By DaveSR71

RE: K&B 6.5 What to do with

Mike
These were designed for use in Rat race and pylon.

They need lots of nitro and small props to get into operating rpm range.
Not enough nitro to "grow' the cylinder will lead to...
Forum: Control Lines
10-01-2010, 12:28 PM
Replies: 16
Views: 2,294
Posted By DaveSR71

RE: piston/sleve identity

Brian
Stumbled across the image on a Google image search will doing some Fox research.

I wish those 2 were in my collection but not!
Do have a twin exhaust O.S. though.

flyingtigre
I...
Forum: Control Lines
09-30-2010, 09:02 AM
Replies: 16
Views: 2,294
Posted By DaveSR71

RE: piston/sleve identity

Brian
Found this.
One on left has what I have come to recognize as sand cast finish
Forum: Control Lines
09-30-2010, 08:50 AM
Replies: 12
Views: 1,995
Posted By DaveSR71

RE: Stunt Contest Oct 16 and 17 Baton rouge La.

Mornin Ace

I believe they have good turnout for both days.

Other than one contest in 1979 I haven't competed in C/L since 1975 NATs.

I posted the event for the CD as his computer was...
Forum: Control Lines
09-29-2010, 05:27 AM
Replies: 16
Views: 2,294
Posted By DaveSR71

RE: piston/sleve identity

I comparing the 5103 to a 5224 with out disassembling:
The 51 is smaller than 52
The 51 appears to be bushing crank.
The 52 appears to be twin ball bearings.
The finish on both engines is...
Forum: Control Lines
09-29-2010, 05:15 AM
Replies: 16
Views: 2,294
Posted By DaveSR71

RE: piston/sleve identity

Brian
3rd post this thread should work on clearing up what the question was/is.
How are the children in Jim's playpen doing? Hope they are getting along.

This winter may have time to do some...
Forum: Electric Indoor & Micro RC Flight
09-28-2010, 10:24 PM
Replies: 47
Views: 7,735
Posted By DaveSR71

RE: Micro DH2

Hey mod
Cant make pic enlarge to see it!!
Can you post pic again and see what happens.

From what little can be seen in the small pic it looks good.
Forum: Electric Indoor & Micro RC Flight
09-28-2010, 10:19 PM
Replies: 2
Views: 704
Posted By DaveSR71

RE: New News is News

Mike
If you go to 200+MHA 1C that should be all that's needed.

At least for me the P-51 is plenty fast.

There is along thread on here for the PZ P-51
Forum: Electric Indoor & Micro RC Flight
09-28-2010, 10:16 PM
Replies: 21
Views: 8,971
Posted By DaveSR71

RE: Flyzone Albatros

Thanks Wheelnut!

trying to share how good it flies with everyone and getting the radio swapped out and flying had me in a rush.

The more I fly it the more I like it.

Very smooth and...
Forum: Control Lines
09-28-2010, 10:08 PM
Replies: 4
Views: 1,234
Posted By DaveSR71

RE: Cub Scout Trainer

No one asked about the missing rudder?

Glad to see someone keeping potential new comers interested!

The Cub Scouts sounds like a good idea. Might check into that this coming summer.
Forum: Control Lines
09-28-2010, 10:05 PM
Replies: 2
Views: 824
Posted By DaveSR71

RE: Challenger flite report

Congratulations Dwayne!

That fly off the board has only happened for me once in the last 5 airplane. Makes life easy!;)
Forum: Control Lines
09-28-2010, 10:03 PM
Replies: 8
Views: 1,694
Posted By DaveSR71

RE: Old Combat

Did the plans above post come through?
Forum: Control Lines
09-28-2010, 10:02 PM
Replies: 16
Views: 2,294
Posted By DaveSR71

RE: piston/sleve identity

Wrong thread
Whoops!
Forum: Control Lines
09-28-2010, 10:01 PM
Replies: 24
Views: 5,124
Posted By DaveSR71

RE: 1/2 A electric

I hope the above post made sense
Forum: Control Lines
09-28-2010, 09:59 PM
Replies: 24
Views: 4,078
Posted By DaveSR71

RE: Gas engine?

Hey vertical
Did you find what you needed?
Forum: Control Lines
09-28-2010, 09:55 PM
Replies: 12
Views: 1,995
Posted By DaveSR71

RE: Stunt Contest Oct 16 and 17 Baton rouge La.

Counting down the days.....
Forum: Electric Indoor & Micro RC Flight
09-25-2010, 01:28 PM
Replies: 21
Views: 8,971
Posted By DaveSR71

RE: Flyzone Albatros

After all morning flying 5 micros I have come to the come to the conclusion that I like this airplane.
Did not weigh any components that were swapped but it flies like it lost some weight. This...
Forum: Electric Indoor & Micro RC Flight
09-25-2010, 03:05 AM
Replies: 21
Views: 8,971
Posted By DaveSR71

RE: Flyzone Albatros

Notice the nice details
Engine, pilot, machine guns.
Looks like I need to add some instrument panel details.

Time to hit the sack and beat the wind in the morning.
My only worry is the PZ...
Forum: Electric Indoor & Micro RC Flight
09-25-2010, 02:59 AM
Replies: 21
Views: 8,971
Posted By DaveSR71

RE: Flyzone Albatros

With pictures this time.
Pictures are from after repair so no quite as nice.

There was no hope for the servo. After working with it and swapping out servo motor and checking and tweeking the...
Forum: Electric Indoor & Micro RC Flight
09-25-2010, 02:35 AM
Replies: 2
Views: 704
Posted By DaveSR71

New News is News

This is update on past post/threads
Been gone from forum for awhile working on a few C/L Competition Aerobatic trimmed for contest and removing rust from the pilot.

Parkzone P-51 with extra...
Forum: Control Lines
09-24-2010, 09:33 PM
Replies: 12
Views: 1,995
Posted By DaveSR71

RE: Stunt Contest Oct 16 and 17 Baton rouge La.

Will bring several
See ya there!
Forum: Electric Indoor & Micro RC Flight
09-24-2010, 09:30 PM
Replies: 21
Views: 8,971
Posted By DaveSR71

Flyzone Albatros

Hi guys

When I saw the Flyzone Albatros just had to have one.
Beautiful little airplane that flies fantastic. Some trim problems, mainly built in warps causing rolling out of loops and...
Forum: Control Lines
09-21-2010, 11:02 PM
Replies: 24
Views: 4,078
Posted By DaveSR71

RE: Gas engine?

There is a Stunt flier in Austraila I think, that runs a 4 stroke with ignition.
Don't know if its gas or meth fueled.

You can run a glow on gas with meth in the mix to keep plug lit.
Try...
Forum: The Clubhouse
09-21-2010, 10:38 PM
Replies: 11
Views: 2,005
Posted By DaveSR71

RE: Help Please Identifing

cutaway 's ID look right.

The red thing looks like an old profile Rat.

The stunter with no covering, red cowl, yellow fuse is a Sig Chipmunk.
Showing results 1 to 25 of 246
 
Page 1 of 10
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.