RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: jeanv
Showing results 1 to 23 of 23
Search took 0.64 seconds.
Forum: Batteries & Chargers
08-20-2007, 02:55 AM
Replies: 11
Views: 3,062
Posted By jeanv

A123 in Large Scale Planes.

Hi,

I have a H9 46% Ultimate and needs to replace the two flight packs. Are these new A123's suitable for this type of planes? I have Powerflites's 6v Regulators; can I use this? Can the...
Forum: RC Nitro Stadium Trucks
10-25-2006, 09:17 PM
Replies: 8
Views: 2,218
Posted By jeanv

RE: Sportworks Mayhem

Hi,

I cannot find an "official" Mayhem ST thread?

Thx
JV
Forum: Electric General Discussion
06-11-2006, 02:29 AM
Replies: 1
Views: 334
Posted By jeanv

PowerFlite Batteries

Hi All,

I have two 4000 mah LiIon PowerFlite packs and I have been flying this for the last two years. I use the supplied Powerflite charger for charging. Can I use another tyoe of charger...
Forum: RC Jets
02-27-2006, 03:11 AM
Replies: 5
Views: 1,480
Posted By jeanv

Mig-15 Composite ARF

Hi,

Anyone know of a nice build thread somewhere for this plane?

Thx
Forum: TEAM RCU - Mike McConville
10-31-2004, 12:06 AM
Replies: 9
Views: 1,236
Posted By jeanv

RE: Ultimate

More...
Forum: TEAM RCU - Mike McConville
10-31-2004, 12:04 AM
Replies: 9
Views: 1,236
Posted By jeanv

RE: Ultimate

Maybe we can go lower today?
Forum: TEAM RCU - Mike McConville
10-27-2004, 07:00 AM
Replies: 9
Views: 1,236
Posted By jeanv

RE: Ultimate

Bernards' one smokes; mine has a built-in thunderstorm....
Forum: TEAM RCU - Mike McConville
10-26-2004, 10:07 AM
Replies: 9
Views: 1,236
Posted By jeanv

RE: Ultimate

At least I have mine flying... :):)

JV
Forum: TEAM RCU - Mike McConville
10-25-2004, 12:22 PM
Replies: 9
Views: 1,236
Posted By jeanv

Ultimate

in South Africa.

Regards
Jean
Forum: ARF or RTF
09-07-2004, 05:24 PM
Replies: 1
Views: 510
Posted By jeanv

Hangar 9 Ultimate UC

Hi,

I have just finished this plane and the Under carraige is badly twisted on the one side. Anyone else have the same problem?

Regards
JeanV
Forum: Giant Scale Aircraft - 3D & Aerobatic
07-23-2004, 01:06 PM
Replies: 140
Views: 15,471
Posted By jeanv

RE: New H-9 Extra330S

Hi All,

Did anyone strengthen the firewall? I have mounted a DA100...

And what did you do to remove the stabs quickly? I am using the Hagar 9 hardware kit and the linkages is very...
Forum: Giant Scale Aircraft - 3D & Aerobatic
07-10-2004, 12:08 PM
Replies: 6
Views: 1,464
Posted By jeanv

"Floating bellcrank"

Hi,

I want to build a floating bellcrank system for my H9 Extra. Anyone have any dimensions for the Servo arms and the bellcranks. Surely there must be some "rules" to get maximum throw on...
Forum: IMAC
02-01-2004, 03:33 PM
Replies: 0
Views: 733
Posted By jeanv

Mega Smoke Pump

Hi,

I have a Mega Smoke Pump and I need to know how to connect and set it up on a JR PCM 10X....

I want to switch it on with the gear switch and adjust the speed with Aux 5.

Thx
Jean
Forum: 3D Flying!
01-21-2004, 11:47 AM
Replies: 231
Views: 21,752
Posted By jeanv

RE: Weston 50 T-1 Broken

Hi All,

I just rx'ed my new T1 today! Should I open it up and check if everything is ok?

regards
Jean
Forum: 3D Flying!
01-19-2004, 10:54 AM
Replies: 231
Views: 21,752
Posted By jeanv

RE: Weston 50 T-1 Broken

What happens if the whole batch that got send to SA was "below standard"? Must I pop all of them?

:):):):)

Jean
Forum: 3D Flying!
01-17-2004, 03:04 PM
Replies: 231
Views: 21,752
Posted By jeanv

RE: Weston 50 T-1 Broken

there is three long grooves in the sleeve (top to bottom); as if only one half of the clip jumped out and "machined" the grooves quite deep into the sleeve... Deep enough to loose all compression.
...
Forum: 3D Flying!
01-17-2004, 12:32 PM
Replies: 231
Views: 21,752
Posted By jeanv

Weston 50 T-1 Broken

Hi,

I had the maiden flight on my 3D Hype with the Weston T1 today. Just to let you know that about 5 minutes into the flight I heard an "expensive" noise and the plane was deadstick. On...
Forum: 3D Flying!
01-15-2004, 03:01 AM
Replies: 231
Views: 21,752
Posted By jeanv

RE: Weston 50 T-1 question

Hi,

I am almost finished with my Hype and was wondering if you guys made any thrust adjustments (right, up, down) after a the first few flights.....

Regards
Jean
Forum: RC Helicopter General Discussions
05-28-2003, 11:21 AM
Replies: 0
Views: 328
Posted By jeanv

Heli Contest Scoring

Hi,

We have a Provincial Heli contest this coming weekend. I have a scoring program from AnnMarie Cross, but was wondering if there is something else available. We will be flying Class I, II and...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
05-27-2003, 04:06 PM
Replies: 5
Views: 642
Posted By jeanv

Heli Software

Hi Annmarie,

Is there any other way I can get hold of this, or do you know of something else?

thanks
Jean
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
05-27-2003, 02:59 PM
Replies: 5
Views: 642
Posted By jeanv

OT: heli contest software beta testers needed

Hi,

I have tried to send mail, but i do not think it is working. Your auto responder does not like me...

can you mail me this software direct?

thx
Jean
Forum: ARF or RTF
04-05-2003, 07:00 PM
Replies: 1
Views: 535
Posted By jeanv

Composite ARF

Hi,

I have a 2.6 m Extra on order and I need to get the hardware to complete it. I will be using JR8411's and I want to get the servo horns. What lengths do I need to order for the Ailerons and...
Forum: 3D Flying!
04-02-2003, 06:43 PM
Replies: 18
Views: 1,411
Posted By jeanv

Freestyle music

Hi,

do you know of any websites (I have the AA site) where we can download some freestyle music?

Thanks
Jv
Showing results 1 to 23 of 23


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.