RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: andy38
Showing results 1 to 25 of 27
Search took 0.57 seconds.
Forum: Extreme Speed Prop Planes
07-25-2009, 08:49 PM
Replies: 30
Views: 10,797
Posted By andy38

RE: OS .35AX

I have just put to gether an extreem flight outlaw with an os35ax with stock mufler and 9*8 apc prop on 15% fuel, I think it would pull 16500rpm.
Forum: Electric RC Jets
07-12-2009, 02:01 AM
Replies: 9
Views: 2,228
Posted By andy38

RE: Fast electrc jet set up??

I have a wemotec min-fan and a mega 16-15-2 motor that i have bench tested runing 4s1p 2300 a123 pack it pulles 54 amps with freashly charged pack but it soon drops to 45 amps as volts sag, under...
Forum: Electric Indoor & Micro RC Flight
08-06-2008, 07:38 PM
Replies: 153
Views: 37,030
Posted By andy38

RE: parkzone vapor ?

I have been having problems getting the ruder to center on the vapor the transmitter trims don't work, I have either full right or left, no adjustment pots on the servo board.
Forum: RC Helicopter General Discussions
06-02-2008, 06:43 PM
Replies: 5
Views: 1,968
Posted By andy38

RE: JR821 servos

But what servos would be best to use?
Forum: RC Helicopter General Discussions
06-01-2008, 09:01 PM
Replies: 5
Views: 1,968
Posted By andy38

JR821 servos

I have a knight 50 glow heli, am new to helis, currently am using 3 jrds821 servos on the swash plate, had one servo brake at the spline shaft at the top of the servo,plastic
too britle, and have...
Forum: Gas Engines
05-18-2008, 09:48 PM
Replies: 1
Views: 669
Posted By andy38

Evolution 35 gas carb adjustment

I have lost my manual and would like to know what are the base high and low needle settings.
Engine is in a pattern plane with apc 17-13 and tunned pipe was running good not now.
Forum: Batteries & Chargers
04-25-2008, 10:06 PM
Replies: 3
Views: 861
Posted By andy38

charging NMH on trition

I have a new 4500nimh 5 cell pack that will not charge more than 300-400milamp, also several other times i have charged nimh
on the triton it has indicated that it finised charging a 1000miliamp,...
Forum: Batteries & Chargers
04-24-2008, 11:22 PM
Replies: 62
Views: 20,277
Posted By andy38

RE: A123 pack life in real world uses?

I have a hxt-63-64b motor,sentilion-100amp hv speed control,2 6s1p a123 packs in series for 12s1p in a e-coverted 4*60.
Two 6s1p packs just fit where the tank was,tank floor still in pace,hatch in...
Forum: RC Pattern Flying
04-19-2008, 09:17 PM
Replies: 1
Views: 678
Posted By andy38

WHERE TO GET TEFLON HEADER TUBING

I have some from centeral hobbies but is too small in diameter, I need 7/8 .875 id tubing,I am using a Evolution 35gt gas
engine and tuned pipe.
Forum: RC Pattern Flying
04-19-2008, 09:16 PM
Replies: 1
Views: 762
Posted By andy38

WHERE TO GET TEFLON HEADER TUBING

I have some from centeral hobbies but is too small in diameter, I need 7/8 .875 id tubing,I am using a Evolution 35gt gas
engine and tuned pipe.
Forum: Gas Engines
03-23-2008, 01:12 PM
Replies: 4
Views: 833
Posted By andy38

running gas ignition engines on E85 ethanol

I have an evolution 35gt in a Sword pattern plane, apc17-13 prop, in flight rpm 8500. One of the advantages of a sperate cycliner head is you can rase the comprestion
without affecting the timing....
Forum: RC Pattern Flying
03-20-2008, 10:31 PM
Replies: 26
Views: 5,884
Posted By andy38

RE: DA50 in a pattern plane?

I test flew my sword 140 pattern plane last week and am pleased with the perfromace, I am using a Evolution 35gt, turns a 17-13apc at 8300rpm in flight.
Forum: RC Pattern Flying
03-17-2008, 11:56 PM
Replies: 69
Views: 17,708
Posted By andy38

RE: Sword 2M pattern plane

I test flew my 140 sword over th weekend and am pleased with the way it flys, even though its over 11lbs it flys well.What props and rpm are you guys geting,
I have a Evolution 35gt gas withe...
Forum: Futaba Radios Direct support forum
03-11-2008, 11:42 PM
Replies: 7
Views: 1,155
Posted By andy38

RE: 2.4 GHZ rx battery

I would agree with you on 72mhz,but 2.4 is different,last weekend i saw a very large 3d plane,da85 pitts python fly on one
battery, no gliches flew perfect.
Forum: Futaba Radios Direct support forum
03-09-2008, 09:38 PM
Replies: 7
Views: 1,155
Posted By andy38

RE: 2.4 GHZ rx battery

can you run a single 4cell sub c pac as a recever/ignition battery and not have radio problems, I have a futaba 7c 2.4
and a evolution 35cc in a 2m pattern plane I am trying to save some weight.
Forum: RC Pattern Flying
12-21-2007, 11:26 PM
Replies: 69
Views: 17,708
Posted By andy38

RE: Sword 2M pattern plane

Thats texasrcplanes.com sorry. recieved the plane Quality looks good for a $200.00 ARF, the manual is junk looks like it
was printed out on a home PC, the only problem I see with the plane at the...
Forum: RC Pattern Flying
12-07-2007, 12:29 AM
Replies: 69
Views: 17,708
Posted By andy38

RE: Sword 2M pattern plane

You can get the sword 140 from texasrc.com I have just orderd one,I do not intend to fly competition so i don`t care if it is over 11lb
I am going to use an evolution35 gas with a tunned pipe,I...
Forum: Batteries & Chargers
11-11-2007, 11:12 PM
Replies: 14
Views: 5,813
Posted By andy38

RE: Im building a 12S A123 from dewalt pack

I have just recently started using a123 cells in a 12s1p configeration,2x 6s1p,I am also biulding some 4s1p packs
for use in smaller plane with axi 2820-10,at th present time i am charging with 2...
Forum: Glow to Electric Conversions
10-20-2007, 02:17 AM
Replies: 3
Views: 1,196
Posted By andy38

RE: Sig 4*60. Anyone electrified it?

I have just started converting my old glow 4*60 as a test bed for my new hxt-63-64b motor,ocmre 100amp esc,12s1p a123 batteries
have just static tested the motor with a apceE 17*12 prop and it...
Forum: E-Flight Power Sources
10-05-2007, 09:29 PM
Replies: 1
Views: 633
Posted By andy38

HXT-63-64B MOTOR

Has anyone used the HXT-63-64B 230KV outruner.
I have just received mine and am planing to use 12s1p a123 cells and prop it to 45amps too start with.
Forum: Glow to Electric Conversions
07-13-2007, 11:09 PM
Replies: 0
Views: 501
Posted By andy38

25glow combat

I have a 25size scale combat plane I am converting to E-power,setup AXI2820-10,thunderdird54 speed control,
4s1p a123 M1 cells, bench test 520watts APC1010E should unload in flight some.
Have...
Forum: RC Pattern Flying
07-07-2007, 09:38 PM
Replies: 3
Views: 1,147
Posted By andy38

looking for a 2meter pattern plane for 35cc gas

Could someone tell me witch 2 meter pattern plane, would best take a Evolution 35cc gas engine.
I allready have the engine currently in a chip hyde tunnel vission.
Forum: Classic RC Pattern Flying
07-06-2007, 11:37 PM
Replies: 1
Views: 517
Posted By andy38

looking for 2meter for 35cc gas

Could someone tell me witch 2 meter pattern plane could take the Evolution 35cc gas
engine,I allready have the engine in a chip hyde tunnel visssion currently.
Forum: Batteries & Chargers
05-20-2007, 04:02 PM
Replies: 2
Views: 6,282
Posted By andy38

RE: NEW! - Hyperion EOS1210i and EOSLBA10-A with A123 support

I don't think it will charge a 12s1p a123 pack at 10 amps.
Forum: Batteries & Chargers
05-13-2007, 01:04 PM
Replies: 62
Views: 20,277
Posted By andy38

RE: A123 pack life in real world uses?

can someone tell me if the astroflight 110D charger auto detects the number of cells or is it set by the user. I want to use it with the
LiipoDapter+ to charge M1 cells.
Showing results 1 to 25 of 27
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.