RCU Forums - Search Results

Search: Posts Made By: janfloris

Showing results 1 to 12 of 12
Search took 0.52 seconds.

Forum: Glow Engines

09-01-2012, 08:52 AM

Replies: 4

OS 50SX-H dies when glow removed

Views: 876

Posted By janfloris

RE: OS 50SX-H dies when glow removed

I leaned out the engine, and it almost worked! :D
After replacing the BRAND NEW glow plug with another used one, the engine runs like a dream again... go figure. :eek:

Thank you for all your...

Forum: Glow Engines

08-30-2012, 10:11 AM

Replies: 4

OS 50SX-H dies when glow removed

Views: 876

Posted By janfloris

OS 50SX-H dies when glow removed

Hi

I am ready to chuck my OS50SX-H out the window

Let me start at the beginning. I had a crash with the raptor 50 v2 - lost the tail and it slammed to the ground from about 7 feet up. After...

Forum: JR Radio & Spektrum Radios

04-23-2012, 09:32 PM

Replies: 3

DX8 servo twitching

Views: 1,694

Posted By janfloris

DX8 servo twitching

Hi

I have a question regarding the Spektrum DX8 I just bough.

When giving elevator input on my DX8, at the point just above and/or below center stick, the aileron servo twitches. I am not...

Forum: JR Radio & Spektrum Radios

03-02-2012, 09:53 AM

Replies: 0

JR X2720 to 2.4GHz?

Views: 2,057

Posted By janfloris

JR X2720 to 2.4GHz?

Hi.

Will it be possible to convert the JR 2720 Synthesized Transmitter to 2.4GHz using this Corona DSSS kit?
...

Forum: Kyosho Helicopters

07-09-2008, 06:32 AM

Replies: 9

Initial pitch range question

Views: 1,722

Posted By janfloris

RE: Initial pitch range question

Where can I get Xfuel. Who sells it?

Forum: Kyosho Helicopters

07-09-2008, 02:00 AM

Replies: 9

Initial pitch range question

Views: 1,722

Posted By janfloris

RE: Initial pitch range question

Yes I use castor fuel. 15% nitros. Should I try the synthetic ones? It does have the stock fan on.

Forum: Kyosho Helicopters

07-08-2008, 06:15 AM

Replies: 9

Initial pitch range question

Views: 1,722

Posted By janfloris

RE: Initial pitch range question

I just took it out for a flight - the first since I repaired it after the crash of last Saturday. It was a bit wobbly at times, but I just lowered the pitch a little and increased the throttle. The...

Forum: Kyosho Helicopters

07-08-2008, 04:17 AM

Replies: 9

Initial pitch range question

Views: 1,722

Posted By janfloris

RE: Initial pitch range question

Thank you for the info. What are your pitch values for normal and idle1 modes with your Caliber 3? Also, what is your throttle curve like? I have a Irvine .39 in mine. Will something like -4,6,9 deg...

Forum: Kyosho Helicopters

07-07-2008, 08:19 AM

Replies: 9

Initial pitch range question

Views: 1,722

Posted By janfloris

Initial pitch range question

Hi. I have a Caliber 3 and I use a JR 2610 radio. I have a question (probably a stupid one). Most of the guys say that before you setup any curves ect on the radio, your pitch range shoud be more or...

Forum: Kyosho Helicopters

07-03-2008, 04:36 AM

Replies: 1

Needle Valve settings

Views: 1,163

Posted By janfloris

Needle Valve settings

Hi.

I have a Kyoho Caliber 3 heli with an Irvine .39 engine. I am very happy with the heli. The only thing I'm not 100% sure of is the correct way of going about setting the low-end and top-end...

Forum: Kyosho Helicopters

07-03-2008, 04:34 AM

Replies: 3

Caliber 3 with Irvine .39

Views: 1,181

Posted By janfloris

RE: Caliber 3 with Irvine .39

Yes it does. If you bump full collective while in a hover the rmp (and obviously headspeed) drops.

Forum: Kyosho Helicopters

03-25-2008, 08:17 AM

Replies: 3

Caliber 3 with Irvine .39

Views: 1,181

Posted By janfloris

Caliber 3 with Irvine .39

Hi

Does anyone have any experience with a Irvine .39 motor on a Caliber 3? I am struggeling a bit to keep the headspeed constant during flight. (Only "up and down" hover at this stage). My pitch...

Showing results 1 to 12 of 12