RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: P-38 DRIVER
Showing results 1 to 8 of 8
Search took 0.52 seconds.
Forum: Kit Building
10-02-2007, 09:49 AM
Replies: 4
Views: 845
Posted By P-38 DRIVER

RE: Scale Props - where to purchase?

There is solo props that you can adjust to get the correct rpm for your engine. I've used them and thay work well and are very scale. Check them out at www.soloprops.com
Forum: Kit Building
05-01-2007, 05:14 PM
Replies: 10
Views: 1,562
Posted By P-38 DRIVER

RE: HELP ME WITH MY PICA P-51

Mike
The Q42 should fly it ok, as long as you keep it as light as possible. I assume this is your first Pica. The CG on the plans is not accurate, its too far forward. Is should be 1" forward of...
Forum: Kit Building
04-30-2007, 04:19 PM
Replies: 10
Views: 1,562
Posted By P-38 DRIVER

RE: HELP ME WITH MY PICA P-51

I too am building a Pica 1/5 Mustang, my second one. Building this one a little differently. I didn't like the hole in the fin, so I modified the elevator by cutting out the center area for the...
Forum: Kit Building
04-13-2007, 07:57 AM
Replies: 10
Views: 1,562
Posted By P-38 DRIVER

RE: HELP ME WITH MY PICA P-51

I have the instruction plan book if you still need it.

Bill
Forum: Kit Building
04-12-2007, 04:23 PM
Replies: 3
Views: 836
Posted By P-38 DRIVER

RE: Pica 1/5 scale Mustang, engine and control surface hingeing

No I never took any pictures of the control hinging before it got buried in the fus. I wish I had. After building the elevator per the plan I cut the middle out of the leading edge so all I had was...
Forum: Kit Building
04-12-2007, 03:18 PM
Replies: 3
Views: 836
Posted By P-38 DRIVER

RE: Pica 1/5 scale Mustang, engine and control surface hingeing

This post might be too late. I too am building a Pica Mustang. I using a 3W50i. Mounting it shouldn't be a problem. Cut the opening in the original fire wall to accomidate the engine and build a...
Forum: Questions and Answers
11-03-2006, 09:22 AM
Replies: 8
Views: 2,237
Posted By P-38 DRIVER

RE: Halls Bulldog Racer

Thanks to both of you for the help.
Forum: Questions and Answers
11-02-2006, 12:37 PM
Replies: 8
Views: 2,237
Posted By P-38 DRIVER

Halls Bulldog Racer

I'm looking for plans for the Halls Bulldog Racer up to 1/3 scale. Any help would be appreciated. Thanks.
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.