RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: DK64
Showing results 1 to 25 of 62
Search took 0.73 seconds.
Forum: RC Helicopter General Discussions
04-07-2002, 06:28 AM
Replies: 14
Views: 905
Posted By DK64

Holding your TX???

I use thumbs only for both airplanes and helis.
Forum: RC Helicopter General Discussions
04-01-2002, 04:40 AM
Replies: 7
Views: 818
Posted By DK64

Re: That tight?

If they are too loose then if/when you accelerate too fast and the blades are not spinning fast enough to keep them centered then they will fold resulting in a boom strike. Like they said above,put...
Forum: RC Flight Simulator Software
03-27-2002, 06:43 AM
Replies: 10
Views: 1,152
Posted By DK64

Can I purchase a G2 transmitter Interface separately?

yes, you will have to have your local hobby shop order it from great planes. I don't remember the exact part number but they should know it. Last time I checked the interface was about $75-80.00.
Forum: Batteries & Chargers
02-27-2002, 03:17 AM
Replies: 5
Views: 811
Posted By DK64

info on H9 sure cycle cycler

it would probably take somewhere around 7.5 hours to charge the 1100mah battery at 150.
Forum: Batteries & Chargers
02-27-2002, 12:02 AM
Replies: 5
Views: 811
Posted By DK64

info on H9 sure cycle cycler

naaa...I run all Nicds.......
Forum: Batteries & Chargers
02-26-2002, 08:13 AM
Replies: 5
Views: 811
Posted By DK64

info on H9 sure cycle cycler

yeah, I have one and it works great got it about 3 months ago and it is my main charger. the only thing i wish it would do is stop charging when the battery is peaked but all in all I don't think you...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-22-2002, 03:41 PM
Replies: 6
Views: 737
Posted By DK64

JR Rx question

have you tried relocating that antenna and such? what about your other planes? do they range check fine? I don't know which radio you have but did you know with radios that have modules that if you...
Forum: Batteries & Chargers
02-15-2002, 03:38 AM
Replies: 7
Views: 1,463
Posted By DK64

Why does my 4.8 volt rx batt. read 5.5 volts when I check it?

actually, 4.8 v is almost dead and 5.4-5.5 is fully charged and that is assuming that your tester puts a load on it.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-15-2002, 12:51 AM
Replies: 53
Views: 5,317
Posted By DK64

Hitec radio systems, inexpensive and good quality?

there is a manuals section where you can download it for free.
Forum: Profile and Fun Flying Planes
02-14-2002, 08:09 AM
Replies: 27
Views: 3,972
Posted By DK64

Fun Tiger Extra arf

I know two people who have had it and neither were happy with theirs.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-14-2002, 06:29 AM
Replies: 53
Views: 5,317
Posted By DK64

Hitec radio systems, inexpensive and good quality?

sorry, already went through all of that (scroll through the thread) if you want more download the manual as I am tired of typing.If after all these posts you still think that I would sit here and...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-14-2002, 03:06 AM
Replies: 53
Views: 5,317
Posted By DK64

Hitec radio systems, inexpensive and good quality?

I never said anything about their quality being bad, that was someone else. as far as "you get what you pay for", dazzler was complaining that the JR was too expensive and what I meant by that is...
Forum: Glow Engines
02-14-2002, 02:52 AM
Replies: 13
Views: 2,796
Posted By DK64

Tank size for TT.46 pro

It all depends on how the engine is going to be proped and if you run full throttle all the time or not.

I myself would go with a 10 oz tank.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-14-2002, 01:13 AM
Replies: 53
Views: 5,317
Posted By DK64

Hitec radio systems, inexpensive and good quality?

I never said anything about their recievers or servos infact, I think that they make pretty good recievers and servos. All the servos in my 1/4 Laser are hitec and no problems. I myself do not...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-14-2002, 12:59 AM
Replies: 1
Views: 805
Posted By DK64

rx battery size?

anywhere from 1100 to 1800 or even bigger but the least I would use is 1100. In my 1/4 laser I have a 1800 JR EXTRA pack.
Forum: Glow Engines
02-13-2002, 07:33 AM
Replies: 9
Views: 865
Posted By DK64

Webra 1.20 Break in (non ringed)

Hmmm....didn't know they made a non-ringed version (or do they?) Was it modified with a non-ringed piston? just curious.

As far as break-in I don't see why it would be any different from any other...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-12-2002, 11:44 PM
Replies: 53
Views: 5,317
Posted By DK64

Hitec radio systems, inexpensive and good quality?

No heat, thats your opinion. everyone has their own! :rolleyes:
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-12-2002, 05:02 AM
Replies: 12
Views: 1,435
Posted By DK64

How to use Expo

actually, you would put -30 on low and -50 on high rates

the higher the number, the more it softens it around the middle.

I would start at around -30 on low and -50 on high and move up
(or...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-12-2002, 04:21 AM
Replies: 53
Views: 5,317
Posted By DK64

Hitec radio systems, inexpensive and good quality?

Yes, the hitec is a good price, but it just doesn't have ALL the features of other radios. It does have almost all the features you would need to fly a plane but for heli's there are some features...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-12-2002, 02:55 AM
Replies: 53
Views: 5,317
Posted By DK64

Hitec radio systems, inexpensive and good quality?

Yes, right above the throttle stick....
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-12-2002, 02:51 AM
Replies: 12
Views: 1,435
Posted By DK64

How to use Expo

On futaba it is -30 to soften it up around the middle and on JR it is +30 to soften up around the middle
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-11-2002, 10:48 PM
Replies: 53
Views: 5,317
Posted By DK64

Hitec radio systems, inexpensive and good quality?

and just where did you hear that?

I use all of those functions on my heli and sometimes my planes.the only thing that the eclipse has over the 8103 is the throttle cut button but for that I just...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-11-2002, 10:09 PM
Replies: 53
Views: 5,317
Posted By DK64

Re: Newly purchased Ecllipse 7

Alot of people are sponsored by JR and futaba. One local flyer at our field is also sponsored by futaba. Also, the hitec 7 doesn't have all the features the JR 8103 or Futaba 8 or 9cap has and I am...
Forum: Q-500 Racing
02-10-2002, 06:23 AM
Replies: 7
Views: 1,272
Posted By DK64

dominator

Don't know about sepulveda, but in whittier the 424 class used thunder tiger pro .40's unmodified and a 9x6 apc prop. that was the only engine used. for the 428 class everyone uses nelsons so, when...
Forum: Glow Engines
02-10-2002, 02:53 AM
Replies: 8
Views: 1,322
Posted By DK64

OS 52 Surpass Request for Info

if you wanted to hover a .40 sized plane with a four stroke and have unlimited vertical you would need about a .70 four stroke.
Showing results 1 to 25 of 62
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.