RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 5
1
2
3
Last »
Search: Posts Made By: RCGeckoman
Showing results 1 to 25 of 119
Search took 1.28 seconds.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-13-2010, 01:31 PM
Replies: 12
Views: 1,455
Posted By RCGeckoman

RE: Airtronics RDS8000

ok step by step 2 x ailerons and 2 x flaps ...

1. Got to tht etc section of the radio.
2. Choose the 1st C mix.
3. Make the master = AI
4. Make the Slv = 7
5. Make A->7 = 100% for BOTH...
Forum: RC Helicopter General Discussions
02-10-2010, 07:20 PM
Replies: 7
Views: 951
Posted By RCGeckoman

RE: Hobby King

They take about 3 weeks. I have ordered from them a lot and they are always worth the wait :)

Dave L
Forum: Airtronics Support Forum
02-05-2010, 09:36 PM
Replies: 2,617
Views: 364,115
Posted By RCGeckoman

RE: *Airtronics RD8000 2.4 GHz*

From everything you have said, youhave NOT proven it was a broken wire, nor have you returned the radio to Airtronics to find the root cause of your problems. For all you know it couldhave been a bad...
Forum: Airtronics Support Forum
02-04-2010, 06:41 PM
Replies: 2,617
Views: 364,115
Posted By RCGeckoman

RE: *Airtronics RD8000 2.4 GHz*

ALL of the radios have had problems with them in one way or another. but it is your choice where you spend your money :)

Mine has gone on an Airtronics SD10-G...no complaints abuot that radio at...
Forum: Airtronics Support Forum
02-04-2010, 06:13 PM
Replies: 2,617
Views: 364,115
Posted By RCGeckoman

RE: *Airtronics RD8000 2.4 GHz*

Check the wire to theruidder pot. Mine broke and possibly caused the loss of three models that I put down to dumb thumbs. Soldering the wire back on cured the problem, but I bought an SD10-G instead...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-02-2010, 10:37 AM
Replies: 17
Views: 4,663
Posted By RCGeckoman

RE: Sanwa/Airtronics RD8000 problems !

I have completed the mode change from 1 to 2 and i had no problems at all. Following the steps from the link, you will aslo need to rcalibrate your sticks after you have switched to mode 2 in the svc...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-01-2010, 01:19 AM
Replies: 885
Views: 163,352
Posted By RCGeckoman

RE: MAN reports on Airtronics SD-10G 2.4Ghz radio system

you have the newer controller then, it should not be a problem though. Ihave made a cable but the controls are not good...jittering all over the place so I will get out an dbut some new parts and...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-31-2010, 12:53 AM
Replies: 885
Views: 163,352
Posted By RCGeckoman

RE: MAN reports on Airtronics SD-10G 2.4Ghz radio system

I'll let you know once I get it working....what controller do youhave?? I have the original one from RF 3....if the wiring is the same with the later version that came with version 4 and 5 then it...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-30-2010, 04:07 PM
Replies: 885
Views: 163,352
Posted By RCGeckoman

RE: MAN reports on Airtronics SD-10G 2.4Ghz radio system

I am working on something similar right now for Real Flight...do a search on the web for cables for FMS and see if you can find the pinouts, then it is just a matter of joining the two of them...
Forum: Airtronics Support Forum
01-27-2010, 11:36 AM
Replies: 2,617
Views: 364,115
Posted By RCGeckoman

RE: *Airtronics RD8000 2.4 GHz*

The manual DOIES actually say that, and it wil lonly work with the FHSS3 Rx's. I know, I have it setup and none of the choices work on the 8 channel RX.

Dave L
Forum: Airtronics Support Forum
01-27-2010, 11:34 AM
Replies: 2,617
Views: 364,115
Posted By RCGeckoman

RE: *Airtronics RD8000 2.4 GHz*

That is correct BUT it ONLY works with the SD10 Rx. It will NOT work witht he RDS*))) Rx! it is a feature of the 10 channel equipment.

Dave L
Forum: Airtronics Support Forum
01-25-2010, 02:56 PM
Replies: 2,617
Views: 364,115
Posted By RCGeckoman

RE: *Airtronics RD8000 2.4 GHz*

Where in NC are you? if you can get over to the $RDRC field sometime you can take a look and feel of my SD10.

The only rx's so far with the abillity to use the model select is the sd10s own Rx....
Forum: Airtronics Support Forum
01-24-2010, 08:07 PM
Replies: 2,617
Views: 364,115
Posted By RCGeckoman

RE: *Airtronics RD8000 2.4 GHz*

I have both the RDS8000 and the SD10-G. Neither of them has any slop at all in either of the sticks. I have not, yet, installed the heavier springs in the SD10-G, but am looking to do that just to...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-19-2010, 05:32 PM
Replies: 8
Views: 1,400
Posted By RCGeckoman

RE: RDS8000 2.4 ERR2?

Try reversing the throttle....see if that resolves it, and make sure the trim is all the way down as well to be sure.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-09-2010, 09:55 AM
Replies: 4
Views: 853
Posted By RCGeckoman

RE: Need Adminsrator To Add SD-10G To User Review Choices

The SD10-G is one of the best radios currently available....what do you want to know about it?

Dave L
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-09-2010, 12:20 AM
Replies: 885
Views: 163,352
Posted By RCGeckoman

RE: MAN reports on Airtronics SD-10G 2.4Ghz radio system

ROFL...that is funny :) but you are right!!!
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-20-2009, 11:49 PM
Replies: 885
Views: 163,352
Posted By RCGeckoman

RE: MAN reports on Airtronics SD-10G 2.4Ghz radio system

weird...mine slides out as easy as pie....try pulling the battery out and seeing if that makes things easier....ie pull the pack and it might free the cable some and make it easier in the socket
Forum: Airtronics Support Forum
09-14-2009, 06:53 PM
Replies: 2,617
Views: 364,115
Posted By RCGeckoman

RE: *Airtronics RD8000 2.4 GHz*

there are also a lot of good examples on the airtronics website. take some time to go look at them and see what can be done, then decide what you want to do.
Expo is avialbale on both elevator and...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-12-2009, 10:11 PM
Replies: 885
Views: 163,352
Posted By RCGeckoman

RE: MAN reports on Airtronics SD-10G 2.4Ghz radio system

<grin> Maybe Ineed to see how much it would cost to produce a chair/jacket/hat etc...printing is a sideline... hmmm....pity the logo is copyright :*)
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-11-2009, 11:15 PM
Replies: 885
Views: 163,352
Posted By RCGeckoman

RE: MAN reports on Airtronics SD-10G 2.4Ghz radio system

yup..the holes just gave the radio an unfinished look...now a chair and a real nice Tx case would be nice...a blue one to match the chair :) and a hat rather than a cap...and a jacket....and......
Forum: Airtronics Support Forum
09-11-2009, 05:34 PM
Replies: 2,617
Views: 364,115
Posted By RCGeckoman

RE: *Airtronics RD8000 2.4 GHz*

you can use teh tip and the shield, leave the central part disconnected. That should do it.
Dave L
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-11-2009, 11:42 AM
Replies: 885
Views: 163,352
Posted By RCGeckoman

RE: MAN reports on Airtronics SD-10G 2.4Ghz radio system

yup....I was worried that the programming wouldbe hard to work out...but it is not a problem!! I love it :)
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-11-2009, 09:51 AM
Replies: 885
Views: 163,352
Posted By RCGeckoman

RE: MAN reports on Airtronics SD-10G 2.4Ghz radio system

Airtronics did a great job..BUT it does not balance where *I* want it to...so what is the problem?? The holes look ugly and detract from an otherwise nice design...I have found a way to make it...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-10-2009, 10:37 PM
Replies: 7
Views: 4,355
Posted By RCGeckoman

RE: More new Airtronics 2.4Ghz FHSS receivers, Cirrus - Airtronics radio

<grin> as an English ex-pat I accept your compliment mate ;*)

the holes irritated me and the balance with the extender is more comfortable to me.. East RC is my LHS (24 miles away!!) and they go...
Showing results 1 to 25 of 119
 
Page 1 of 5
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.