RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Gibby 11
Showing results 1 to 22 of 22
Search took 0.74 seconds.
Forum: RC Car General Discussions
01-21-2007, 11:16 PM
Replies: 3
Views: 321
Posted By Gibby 11

RE: MT 5

Thanks for the quick response ---It's actually at the main diff gear where it meshes with
the gear on the shaft that meshes with the gear on the clutch...
Forum: RC Car General Discussions
01-21-2007, 11:09 PM
Replies: 3
Views: 321
Posted By Gibby 11

MT 5

I recently purchased a used MT 5 and the gear mesh at the diff
has become loose... Any qiuck ideas on adjustment..........

Thanks Rob
Forum: JR Radio & Spektrum Radios
02-04-2004, 10:13 AM
Replies: 3
Views: 530
Posted By Gibby 11

RE: 8103

Thanks Danny !!! I knew if it could done you would know how !!! You are such an asset to us out here we really appreciate your time and understanding.

Rob Gibson
Forum: JR Radio & Spektrum Radios
02-04-2004, 02:51 AM
Replies: 3
Views: 530
Posted By Gibby 11

8103

OK Danny, One more !!! I am wanting to mix my brakes with down elevator, Is it possible to have this mix switched on with the gear switch so it will only mix with the gear down.

TIA......Rob...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-31-2004, 06:23 PM
Replies: 2
Views: 333
Posted By Gibby 11

RE: My helicopter won't recognize my Throttle!!!

I have used a "super 7" for 8 years with no problembs-- If the pitch servo is working I would check the throttle hold switch & idle up switch you may heve bumped it !!! This would allow the pitch...
Forum: JR Radio & Spektrum Radios
01-31-2004, 06:17 PM
Replies: 1
Views: 477
Posted By Gibby 11

8103 PCM

Hey Danny,

Just got my new 649s and set it all up !!! The range seems to be off-When I go to spcm with the antenna down range is only about 5 feet---regardless of direction or antenna route. ...
Forum: JR Radio & Spektrum Radios
01-28-2004, 10:49 AM
Replies: 3
Views: 505
Posted By Gibby 11

RE: 8103

I was afraid of that Danny-- any chance I could swap one of my aux knobs to a spring loaded switch?????
Forum: JR Radio & Spektrum Radios
01-28-2004, 01:45 AM
Replies: 3
Views: 505
Posted By Gibby 11

8103

Hey Danny,

Any chance I can assign my trainer switch to a rx channel---spring loaded would be killer for a turbine wheel brake.

Thanks
Rob
Forum: RC Jets
01-28-2004, 01:40 AM
Replies: 5
Views: 575
Posted By Gibby 11

RE: Roo question

No , I bought it used and apperantly they were siliconed on thier side right to the panels !!!!!!
Forum: RC Jets
01-26-2004, 11:45 PM
Replies: 5
Views: 575
Posted By Gibby 11

Roo question

I was wondering whats the best way to attach servos (on thier side) to the removable panels... I bought her already built so no instructions.

Thanks

Rob
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-25-2004, 08:30 PM
Replies: 1
Views: 418
Posted By Gibby 11

PCM 8103

I turn to the Guru's once again. I am converting my 8103 to pcm for turbine---Which 8 ch rx would be best ??? I read you can't run "boosted" extensions on a certain rx,,, I think it was a 549---so...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-22-2004, 10:27 AM
Replies: 0
Views: 471
Posted By Gibby 11

JR 8103 & THE ROO

Is anybody using this set-up ??? Sure could use help with channel assignment etc. I figuer this is the best place since I am new and this place is full of Guru's. I also posted this in the Jets...
Forum: RC Jets
01-22-2004, 10:24 AM
Replies: 4
Views: 652
Posted By Gibby 11

8103 & ROO

Is anybody using this set-up ??? Sure could use help with channel assignment etc. I figuer this is the best place since I am new and this place is full of Guru's.

Thanks Rob
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-11-2004, 08:09 PM
Replies: 12
Views: 1,212
Posted By Gibby 11

RE: JR 8103

Thanks again Guys --Flew today and all was well , Gotta love this so-cal wheather. I did pick up some extra fuses @ radio shack so if someone in my club has this prob I will be a hero.

This...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-11-2004, 03:08 AM
Replies: 12
Views: 1,212
Posted By Gibby 11

RE: JR 8103

Thanks Guys, You were right on the money, I removed the module and found the fuse --It looked fine but did not pass the continuity test so I made a jumper just for a test and It worked fine , New...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-11-2004, 12:47 AM
Replies: 12
Views: 1,212
Posted By Gibby 11

JR 8103

Just wondering if anybody has had this happen ---- I was setting up a plane last night and left my tx on the bench, I went to plug her in to charge for tommorrow and no red light on the charger !!!! ...
Forum: RC Jets
11-10-2003, 12:39 AM
Replies: 4
Views: 690
Posted By Gibby 11

TGA F-15

Anybody have specs for a turbine conversion for the F-15

Thanks Rob
Forum: Glow Engines
06-26-2003, 05:00 AM
Replies: 4
Views: 607
Posted By Gibby 11

Ys F-120

Does anybody have info on this motor

Thanks Rob
Forum: Profile and Fun Flying Planes
06-18-2003, 03:03 AM
Replies: 1
Views: 333
Posted By Gibby 11

Su-Do-Khoi --Balance

I recently was forced to re-build my Su Do Khoi but can not find my original manuel---can someone help with the balance point for me.

Thanks Rob
Forum: Glow Engines
04-12-2003, 05:56 AM
Replies: 1
Views: 553
Posted By Gibby 11

Smoke System

Where would be the recomended place to tap a smoke fitting to a Pitts style muffler on a Moki 2.1--Is smoke oil the best thing to use ?
Forum: Giant Scale Aircraft - 3D & Aerobatic
11-07-2002, 08:07 AM
Replies: 0
Views: 332
Posted By Gibby 11

Cap 232 Canopy

Hi All,
I am looking for a canopy for my 1/4 scale H 9 Cap 232, I know they are not made anymore by H 9, And am looking for a replacement.

Thanks Rob.
Forum: RC Helicopter General Discussions
04-04-2002, 06:16 AM
Replies: 1
Views: 329
Posted By Gibby 11

Super 7

Hey just wondering if anybody has 3 D setups for a super 7 , I am starting up again after a couple years off and lost my notes.

X-CELL 60 and FP-T7UHF SUPER.

Thanks Rob
Showing results 1 to 22 of 22


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.