RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: barryp
Showing results 1 to 16 of 16
Search took 0.43 seconds.
Forum: Aerial Photography and Video
03-26-2008, 08:56 AM
Replies: 19
Views: 9,148
Posted By barryp

RE: FlyCamOne2 and cold temperature problems

I had the same experience. The card has to be pushed deeper in to the camera body in order to lock or release. I use a small piece of thin ply as a "pusher" stick.
Forum: Aerial Photography and Video
02-25-2008, 07:14 AM
Replies: 6
Views: 4,100
Posted By barryp

RE: FlyCamOne2 cold temperature solution

Hi TruBlu02,

I don't know much more about the mounting base and it's connective functions beyond the information in the manual. In addition to power for the camera, it provides a channel for the...
Forum: Aerial Photography and Video
02-23-2008, 02:05 PM
Replies: 6
Views: 4,100
Posted By barryp

RE: FlyCamOne2 cold temperature solution

Yes, TruBlu02 that would be correct for a glow/gas powered aircraft. Thank you for catching this.

The wiring set-up I initially described was for an electric powered system where the power...
Forum: Aerial Photography and Video
02-18-2008, 05:25 PM
Replies: 6
Views: 4,100
Posted By barryp

FlyCamOne2 cold temperature solution

Here is a solution to cold temperature problems with the FlyCamOne2. Use the Rx batteries (glow-gas power) or power from your ESC-BEC (electric power) to power the FlyCamOne2. A simple tap made from...
Forum: Aerial Photography and Video
02-18-2008, 05:05 PM
Replies: 19
Views: 9,148
Posted By barryp

RE: FlyCamOne2 and cold temperature problems

Here is a solution to cold temperature problems with the FlyCamOne2. Use the Rx batteries (glow-gas power) or power from your ESC-BEC (electric power) to power the FlyCamOne2. A simple tap made from...
Forum: Aerial Photography and Video
01-24-2008, 12:40 PM
Replies: 19
Views: 9,148
Posted By barryp

RE: FlyCamOne2 and cold temperature problems

The problem seems clearly to be the LiPo battery - it doesn't have the capacity to maintain necessary voltage at low temperatures. The solution is not too difficult since the camera requires 5V and...
Forum: Aerial Photography and Video
01-06-2008, 08:19 PM
Replies: 19
Views: 9,148
Posted By barryp

RE: FlyCamOne2 and cold temperature problems

Thank you Deyrick - I've browsed the FlyCamOne site forums, but most of the posts seem to be in German and I haven't found an English version or translation. I may very well try a thermal jacket or...
Forum: Aerial Photography and Video
01-06-2008, 12:22 PM
Replies: 19
Views: 9,148
Posted By barryp

RE: FlyCamOne2 and cold temperature problems

Looking forward to your tests fmimages - I'd like to know the ambient temperature when you do the tests - in relation to this low temperature issue. Did you say you have a comparison with the Sony...
Forum: Aerial Photography and Video
01-06-2008, 12:18 PM
Replies: 19
Views: 9,148
Posted By barryp

RE: FlyCamOne2 and cold temperature problems

Yes - it may well be a LiPo low temperature problem. In my vast amounts of spare time I will devise a mini-heater to run from the flight pack - or maybe just warm the thing up in advance and add an...
Forum: Aerial Photography and Video
01-05-2008, 08:59 AM
Replies: 19
Views: 9,148
Posted By barryp

RE: FlyCamOne2 and cold temperature problems

Short video (compressed to 320x240 @12fps from original 640x480 25fps here: http://www.youtube.com/watch?v=fhGu141LbjQ
Forum: Aerial Photography and Video
01-04-2008, 11:46 PM
Replies: 19
Views: 9,148
Posted By barryp

RE: FlyCamOne2 and cold temperature problems

Quick update - Had received a very prompt response from support at FlyCamOne2 , but it was in my junk mail folder. Their response indicated an upcoming firmware update that would address cold...
Forum: Aerial Photography and Video
01-04-2008, 10:39 PM
Replies: 19
Views: 9,148
Posted By barryp

FlyCamOne2 and cold temperature problems

I just started testing a FlyCamOne2 in the air and it stops recording after 1-2 minutes at temperatures of 10-30 degrees F. LCD display is blank when the plane lands. At room temperature it will...
Forum: JR Radio & Spektrum Radios
05-29-2007, 01:14 PM
Replies: 2
Views: 619
Posted By barryp

RE: ESC connection to receiver

Yes it has BEC - thank you for the help!
Forum: Electric Training
05-27-2007, 07:14 PM
Replies: 2
Views: 572
Posted By barryp

RE: connecting esc to rx

Thanks for the confirmation - I'll be using the connection on the RX labeled THRO (the channels are labeled by function rather than number).
Forum: Electric Training
05-27-2007, 02:53 PM
Replies: 2
Views: 572
Posted By barryp

connecting esc to rx

This is probably obvious - but since I am completely new to RC I have to ask:
I have a Spektrum AR7000 rx and Electrifly ESC. I assume the ESC plugs onto the throttle pins on the rx, but there is...
Forum: JR Radio & Spektrum Radios
05-26-2007, 06:57 AM
Replies: 2
Views: 619
Posted By barryp

ESC connection to receiver

I am new to RC and am installing the radio equip in a Spectra sailplane. I have a Spektrum DX7 system, Electrifly S-600 motor and electrifly C-35 ESC. I understand the theory of hte ESC with BEC, but...
Showing results 1 to 16 of 16


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.