RCU Forums - Search Results

Search: Posts Made By: cabern

Showing results 1 to 5 of 5
Search took 0.35 seconds.

Forum: NitroModels Support

11-20-2007, 10:05 PM

Replies: 10

Nitromodel YAK-54 3d 50 setup

Views: 1,876

Posted By cabern

RE: Nitromodel YAK-54 3d 50 setup

I'm running a saito82 14X4 on this particular setup...so i can only give a guess based on another plane i have. I have a run a 13X4 on my OS 55 AX and it did ok, but close to the ground it's too...

Forum: NitroModels Support

09-27-2007, 08:22 PM

Replies: 10

Nitromodel YAK-54 3d 50 setup

Views: 1,876

Posted By cabern

RE: Nitromodel YAK-54 3d 50 setup

Thanks for the post opjose.

For all that are interested...I pushed the CG back to 5 3/16 inches (apprx 131mm) and my hover stabilized alot. With the CG pushed back, I could tell a little...

Forum: NitroModels Support

09-25-2007, 09:52 PM

Replies: 10

Nitromodel YAK-54 3d 50 setup

Views: 1,876

Posted By cabern

Nitromodel YAK-54 3d 50 setup

This plane is advertised as a 3D plane...does that include hovering? I have mounted a saito 82 inverted with 14X4 APC Wide Blade prop, set CG to recommended setting (4.7 inches) and can not get a...

Forum: 3D Flying!

08-22-2007, 11:33 PM

Replies: 15

MOJO question...

Views: 1,795

Posted By cabern

RE: MOJO question...

Get a mojo. I would rather fly than build, but it's worth every minute once in the air. I'm running a saito 100 with a 16X4 APC with 10% on my mojo 60...works like a charm. I wouldn't trade that...

Forum: 3D Flying!

08-20-2007, 11:32 PM

Replies: 38

learn 3d

Views: 5,203

Posted By cabern

RE: learn 3d

I started learning 3D on a twist 40, with an os 46...progress was slow. I put a saito 82 on it, and it became a brand new plane. I loved it so much, I didn't want to trash it learning...therefore I...

Showing results 1 to 5 of 5