RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: scotty81
Showing results 1 to 25 of 34
Search took 0.34 seconds.
Forum: RC 1/8th Scale Buggies
12-14-2008, 07:02 AM
Replies: 5
Views: 602
Posted By scotty81

RE: CRANKSHAFT PROBLEM

I have just bought the crankcase off ebay bearings installed whats the best way of fix if I have to take the bearing out whats the best method to install it again beacause I have had big problems...
Forum: RC 1/8th Scale Buggies
12-13-2008, 06:08 PM
Replies: 5
Views: 602
Posted By scotty81

RE: CRANKSHAFT PROBLEM

No because I have tried it with the internals out and when I tighten the flywheel I can see the crank pull in to tight on the rear bearing
Forum: RC 1/8th Scale Buggies
12-13-2008, 07:15 AM
Replies: 5
Views: 602
Posted By scotty81

CRANKSHAFT PROBLEM

Hi I have a Novarossi 21-5kt engine when I am tightening the flywheel up tight on the collet the crank seems to be binding on my rear bearing not letting it spin freely any suggestions would be...
Forum: RC 1/8th Scale Buggies
11-26-2008, 06:17 AM
Replies: 4
Views: 685
Posted By scotty81

RE: NOVAROSSI CRANKCASE

what about a plus 21- 7 crankcase would that work with the 5kt internals and does the different port size affect the crankcase or not
Forum: RC 1/8th Scale Buggies
11-19-2008, 05:07 AM
Replies: 4
Views: 685
Posted By scotty81

NOVAROSSI CRANKCASE

Hi guys im chasing a new crankcase for my Novarossi plus 215kt would a p5xs 21 crankcase suit my engine any sugestions would be great thankyou.
Forum: RC 1/8th Scale Buggies
07-22-2008, 07:39 PM
Replies: 2
Views: 416
Posted By scotty81

HYPER 8.5 QUESTIONS

Hi guys just a couple of questions does the jammin big bore shocks fit the 8.5 pro well,if so how do they go and whats a good set up,are they better than the stock shooks. I have a hyper 21 8 port i...
Forum: Car Nitro & Gas Engines
04-25-2008, 06:26 AM
Replies: 2
Views: 462
Posted By scotty81

RE: HELP NOVAROSSI

i grinded it down worked perfect what was wrong with the clutch what do you run now
Forum: Car Nitro & Gas Engines
04-24-2008, 11:14 PM
Replies: 2
Views: 462
Posted By scotty81

HELP NOVAROSSI

I have just purchased a Novarossi 5KT, I have done all the prep work pulled it apart and sealed it. I am trying to fit a werks clutch to it but the collet supplied is like as if it not wide...
Forum: Car Nitro & Gas Engines
04-22-2008, 04:14 PM
Replies: 5
Views: 618
Posted By scotty81

RE: NOVAROSSI 5KT

Is it true that the ofna 086 will do the same as a 9886
Forum: Car Nitro & Gas Engines
04-22-2008, 01:49 AM
Replies: 5
Views: 618
Posted By scotty81

RE: NOVAROSSI 5KT

Great thaks for the reply are you happy with the engine? I am from Australia not racing yet just playing round bmx tracks and stuff the engine is brand new I dont even wanna use it it looks to...
Forum: Car Nitro & Gas Engines
04-21-2008, 06:55 AM
Replies: 5
Views: 618
Posted By scotty81

NOVAROSSI 5KT

Hi guys I have a new novarossi plus 5kt 21 (sweet). I need to know correct needle setting for run in also what are the different colour carb inserts used for also any links to some useful info on...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
04-04-2008, 12:41 AM
Replies: 7
Views: 1,136
Posted By scotty81

RE: SERVO SHUTTERS

YES THERE IS FAILSAFE UNIT ON IT
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
04-03-2008, 05:44 AM
Replies: 7
Views: 1,136
Posted By scotty81

RE: SERVO SHUTTERS

WHAT DO YOU MEAN A RANGE CHECK
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
04-03-2008, 03:45 AM
Replies: 7
Views: 1,136
Posted By scotty81

SERVO SHUTTERS

HI JUST A QUICK QUESTION ON MY HITEC HS 5965 MG IT SEEM TO BE BOUCING AT ITS END POINTS WHEN I OPEN FULL THROTTLE IT WILL BOUNCE AND THE STOP AT END POINT AND THEN WHEN IT CETRES IT DOES THE SAME...
Forum: Car Nitro & Gas Engines
02-27-2008, 06:41 AM
Replies: 1
Views: 603
Posted By scotty81

NOVAROSSI 21 PLUS-21-5T

I was just wondering if you could give me some info on the novarossi plus 21 5t engine, such as performance,the right pipe to suit,glow plugs,clutch and so on I have a hyper 8.5 pro
Forum: Car Nitro & Gas Engines
02-12-2008, 06:16 AM
Replies: 2
Views: 421
Posted By scotty81

RE: HYPER 21 8 PORT! PROBLEM SOLVED!

Can really make them run ordinary when mids up the crap I was chasing my tune it was getting hot all sort of weird stuff was happening
Forum: Car Nitro & Gas Engines
02-12-2008, 04:04 AM
Replies: 2
Views: 421
Posted By scotty81

HYPER 21 8 PORT! PROBLEM SOLVED!

I finaly figured out my engine problem I have a hyper 8.5 pro with a hyper 21 8 port the engine was running terrible getting hot wouldnt idle so I read the forums about MID SPEED NEEDLE I pulled the...
Forum: Car Nitro & Gas Engines
02-11-2008, 06:57 AM
Replies: 7
Views: 559
Posted By scotty81

RE: MIND OF ITS OWN HYPER 21

I think i have found my problem!!! where my fuel line come from the tank its getting a slight kink in it which is making it run lean today at the oval i was tuning it it was fairly rich and all of a...
Forum: Car Nitro & Gas Engines
02-08-2008, 06:40 AM
Replies: 2
Views: 400
Posted By scotty81

RE: problem idle

nothing boiling in the card not vapour lock
Forum: Car Nitro & Gas Engines
02-08-2008, 04:57 AM
Replies: 2
Views: 400
Posted By scotty81

problem idle

I have a hyper 21 8 port I am having trouble with it idling when it gets up to temp i will stop it and it will slow down and die in 1 sec idle screw 1 mm opening also i am having trouble adjusting...
Forum: RC 1/8th Scale Buggies
02-05-2008, 03:15 AM
Replies: 5
Views: 720
Posted By scotty81

RE: HYPER 21 8 PORT

so your talking the main o ring in the throat of the carby or all of them
Forum: RC 1/8th Scale Buggies
02-05-2008, 03:04 AM
Replies: 5
Views: 720
Posted By scotty81

RE: HYPER 21 8 PORT

I thought that air getting in might be a problem this weekend its getting a major overhaul I have rtv silicone is this good for sealing carbs and engine backplate also do you think the front bearing...
Forum: Car Nitro & Gas Engines
02-05-2008, 02:57 AM
Replies: 7
Views: 559
Posted By scotty81

MIND OF ITS OWN HYPER 21

I have a hyper 21 8 port in my 8.5 pro it has done 10 litres just recently it has'nt been holding a good tune one minute it will be peaking out then it will run rich even though its peaking out temps...
Forum: RC 1/8th Scale Buggies
02-05-2008, 02:53 AM
Replies: 5
Views: 720
Posted By scotty81

HYPER 21 8 PORT

I have a hyper 21 8 port in my 8.5 pro it has done 10 litres just recently it has'nt been holding a good tune one minute it will be peaking out then it will run rich even though its peaking out temps...
Forum: RC 1/8th Scale Buggies
01-28-2008, 08:05 AM
Replies: 3
Views: 605
Posted By scotty81

hyper 8.5 pro shocks

I was wondering if anyone could help me I have a hyper 8.5 pro and i keep blowing one shock out dont know why 30 wt in them everytime when i go for a run i look at the left rear shock and all the oil...
Showing results 1 to 25 of 34
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.