RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: TailSpin Walt
Showing results 1 to 15 of 15
Search took 0.33 seconds.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-08-2016, 03:47 PM
Replies: 6
Views: 2,013
Posted By TailSpin Walt

Andy, good information. Tried it out by pulling...

Andy, good information. Tried it out by pulling one remote off while powered on, servo still worked, then when shut off receiver and powered it back on and servo is then nonfunctional.

There is...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-08-2016, 10:09 AM
Replies: 6
Views: 2,013
Posted By TailSpin Walt

I was told by Spektrum, independently of Andy,...

I was told by Spektrum, independently of Andy, that you need to have both remote receiver satellites plugged in other wise you end up with it binding but no actual servo control.
Servo would not...
Forum: Gas Engines
01-21-2012, 07:06 PM
Replies: 5,283
Views: 759,564
Posted By TailSpin Walt

RE: NEW DLE30!

Airraptor, Why is your wot rpm only ~7100. Seems low compared to the 'prop' data on this site. My dle30 ran 7600rpms out of the box, dino 32:1, Xoar 18x8. Am I missing something?
Forum: Gas Engines
12-28-2011, 06:03 PM
Replies: 2
Views: 2,521
Posted By TailSpin Walt

RE: Rear Intake reed problems

Yes! Thanks Ringmaster for posting this incident and solution. My new DLE sounds like it has a very similar, if hot identical, problem.
I had better check it out before I get a relapse of...
Forum: Gas Engines
11-30-2011, 11:48 AM
Replies: 18
Views: 4,190
Posted By TailSpin Walt

RE: DLE spark plugs!!!

Ordered 2 NGK cm-6 plugs from O'Reilly's last week, $3.59 each.
It cost me twice that for one DLE plug from my LHS, I'll be returning.
Forum: NitroModels Support
12-16-2009, 10:41 PM
Replies: 986
Views: 115,742
Posted By TailSpin Walt

RE: NITROMODELS REPLACEMENT PARTS REQUEST_Post Here

The motor mounts for my Nitorplane Super Low Wing Trainer 40 broke where the screws went thru them to mount the motor (not sure why!).
How can I get a new set of motor mounts for this plane?
Forum: Glow Engines
05-30-2009, 08:59 AM
Replies: 6
Views: 912
Posted By TailSpin Walt

RE: Thunder Tiger 54 issue

<font color="#0000ff">Any other ideas?  I have a similar problem with my TT F54-s (airbleed carb version).  Except I can sort of reproduce the problem on the ground by flipping the plane up-side down...
Forum: Glow Engines
03-11-2009, 01:45 PM
Replies: 13
Views: 2,511
Posted By TailSpin Walt

RE: Thunder Tiger F54-S Problem

Jan,

Thanks for the info.
It seems most of the guys here run 15% Nitro because we are at 3500 ft altitude. Normally they would run 10% at sea level. Typically airplane fuel here is 17-20%...
Forum: Glow Engines
03-11-2009, 12:49 PM
Replies: 13
Views: 2,511
Posted By TailSpin Walt

RE: Thunder Tiger F54-S Problem

Hey Thanks.

The airbleed works like do!
Forum: Glow Engines
03-11-2009, 12:12 PM
Replies: 13
Views: 2,511
Posted By TailSpin Walt

RE: Thunder Tiger F54-S Problem

My F-54s is new but it has sat around apparently from the person I bought it from. It does not have the black anodized head like the new ones. However the manual looks the same as the one on-line,...
Forum: Glow Engines
03-11-2009, 11:26 AM
Replies: 13
Views: 2,511
Posted By TailSpin Walt

RE: Thunder Tiger F54-S Problem

I just obtained a new F-54s. Haven't broke it in or anything. Any suggestions on break in? I was plnning on using what the manual said except using 2-cycle fuel 15% nitro and 18% oil blend. What...
Forum: NitroModels Support
11-29-2008, 05:11 PM
Replies: 9
Views: 1,051
Posted By TailSpin Walt

RE: Ordered product problems

John- NitroPlanes, Thanks for the quick responses! -Walt
Forum: NitroModels Support
11-28-2008, 10:28 PM
Replies: 9
Views: 1,051
Posted By TailSpin Walt

RE: Ordered product problems

John, Yes. As if a pilot was in the plane it would be on his right side. The same side as the engine exhuast.
Will it match up to the left half ok?
Thanks, Walt
Forum: NitroModels Support
11-28-2008, 08:01 PM
Replies: 9
Views: 1,051
Posted By TailSpin Walt

RE: Ordered product problems

Regarding my order yhst-17210252890263-59252 from Nitro Model R C Planes of a Super Low Wing Trainer 40. I received this order and started inventory and ironing out some bubbles. On the right wing...
Forum: MRC Charger Product Support (i.e. Super Brain, etc)
02-12-2008, 12:39 PM
Replies: 3
Views: 1,008
Posted By TailSpin Walt

RE: Superbrain 989 green plug

I too recently purchased a SB 989 and would like additional input plugs.
Actually the first time I tried my charger I got a beep and "-5.12 (volt) ERR". I soon discovered the green plug was...
Showing results 1 to 15 of 15


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.