RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: tawney
Showing results 1 to 19 of 19
Search took 0.34 seconds.
Forum: Events, Shows and Fun Flys - Airplanes
02-14-2013, 10:37 AM
Replies: 405
Views: 81,578
Posted By tawney

RE: Twin Cities Auction (Minnesota)

How many airplanes were there? must have been in the hundreds.
Forum: War Room
07-03-2008, 12:58 PM
Replies: 2
Views: 723
Posted By tawney

what's it used for?

What is the smaller of the two cables on the left side of a tiger used for? I'm gonna guess it was for repair or changing tracks. On the same subject, how were the tracks changed from the road to...
Forum: Electric RC Jets
04-10-2008, 11:41 AM
Replies: 4
Views: 1,147
Posted By tawney

RE: slow stick jet

Its kind of a dog with the 11.2 volt battery, but when you put in two 7.4volt it zips right along
Forum: RC Tanks
04-10-2008, 10:39 AM
Replies: 11
Views: 1,234
Posted By tawney

RE: weathering

main board flipped, heat sink added and a fan
Forum: RC Tanks
04-10-2008, 09:40 AM
Replies: 11
Views: 1,234
Posted By tawney

RE: weathering

iron oxide, primer grey, dark brown
Forum: War Room
04-05-2008, 10:15 PM
Replies: 2
Views: 633
Posted By tawney

how did they do that/

I have seen pictures of tiger tank drivers driving with their head and chest out of the hatch. From what I can tell the hatch is off to the side and somewhat higher than the drivers seat. Did they...
Forum: RC Tanks
04-03-2008, 12:45 PM
Replies: 71
Views: 5,315
Posted By tawney

RE: speaking of HL boards

News flash update: installed board no.2 and now it all works like it is supposed to. 50% fail rate on new boards
Forum: RC Tanks
04-03-2008, 08:09 AM
Replies: 71
Views: 5,315
Posted By tawney

RE: speaking of HL boards

boards came from mato, I dont think it is their fault, they were packed well and arrived in good condition.
Forum: RC Tanks
04-03-2008, 07:58 AM
Replies: 103
Views: 28,728
Posted By tawney

RE: HENG LONG TANKS - NEED INFO!

They were shipped bubble wrapped in a box. Shipping was not the problem, there are cold
solder joints should not have got past quality control.
Forum: RC Tanks
04-03-2008, 06:56 AM
Replies: 103
Views: 28,728
Posted By tawney

RE: HENG LONG TANKS - NEED INFO!

dud board, had several poor solder connections. When power switched on, had to wiggle components to get any responce.
Forum: RC Tanks
04-03-2008, 04:09 AM
Replies: 71
Views: 5,315
Posted By tawney

RE: speaking of HL boards

Update: mail man dropped off replacement boards, put in new board, more things wrong with new board than the one that it was replacing. It had so many poor solder joints that it wouldnt even power up...
Forum: RC Tanks
04-03-2008, 03:54 AM
Replies: 103
Views: 28,728
Posted By tawney

RE: HENG LONG TANKS - NEED INFO!

templars be aware if you are one of the unlucky 20% (figure may be low from what I have seen so far) that recive a lemon tank get ready for disapointment. both a freind and I ordered tanks and both...
Forum: Electric RC Jets
03-31-2008, 10:37 AM
Replies: 4
Views: 1,147
Posted By tawney

slow stick jet

comments?
Forum: RC Tanks
03-30-2008, 04:51 PM
Replies: 71
Views: 5,315
Posted By tawney

RE: speaking of HL boards

OK lets take this thread on a slightly diffrent course that may be helpful to people that are having trouble with their boards such as me and would like to take a stab at doing your own repair. How...
Forum: RC Tanks
03-29-2008, 07:51 AM
Replies: 71
Views: 5,315
Posted By tawney

RE: speaking of HL boards

So anyways, back to the subject of repairing boards. I guess that few if any make an attempt at repairs, just throw away and replace with the same and hope it lasts. The point I was trying to make...
Forum: RC Tanks
03-28-2008, 05:40 AM
Replies: 71
Views: 5,315
Posted By tawney

RE: speaking of HL boards

With "gallon bags of blown boards", and all the the other complaints seen on the fourm of the boards being poorly made for the most part there is no sense in using junk boards to replace junk boards....
Forum: RC Tanks
03-27-2008, 06:21 PM
Replies: 71
Views: 5,315
Posted By tawney

speaking of HL boards

After seeing the posts reguarding HL boards and their tendency to go up in smoke, is there anyone or anyplace that repairs them? Has anyone made a parts list and trouble shooting guide for what to...
Forum: RC Tanks
02-29-2008, 11:28 AM
Replies: 5
Views: 630
Posted By tawney

RE: how to?

Thank you for your help, but how nessary is the cooling if you dont run steep grades, tall grass (3ft. snow covering now) or sand?
Forum: RC Tanks
02-29-2008, 09:48 AM
Replies: 5
Views: 630
Posted By tawney

how to?

I just got a Heng Long Tiger1, after reading the posts in this forum I see a lot about flipping the board and or installing fans and heat sinks. My question is how do you open up the hull to get at...
Showing results 1 to 19 of 19


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.