RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: WeirdKooKy
Showing results 1 to 25 of 36
Search took 0.66 seconds.
Forum: RC Monster Trucks
01-12-2003, 10:29 PM
Replies: 7
Views: 754
Posted By WeirdKooKy

I really hate when parts break, so here's what I did.

Thanks for the support all.

Hunter, it's the PC plastic which is the bulletproof stuff. My e-mail is [email protected] let me know if I can help you out.
Forum: RC Monster Trucks
01-11-2003, 03:39 AM
Replies: 7
Views: 754
Posted By WeirdKooKy

I really hate when parts break, so here's what I did.

I'm sorry, what's your point? Are you the moderator, or just someone with a fart of fire? You may have a slight point, but I'm missing your source of passion. Does it really bother you that much,...
Forum: RC Monster Trucks
01-10-2003, 05:28 PM
Replies: 7
Views: 754
Posted By WeirdKooKy

I really hate when parts break, so here's what I did.

I scratched my head a bit for this one, I had to figure out how to make the mounts for the a-arm on a homemade bulk-head support. I decided to notch out the plastic and slide the mount into the notch...
Forum: RC Monster Trucks
01-10-2003, 05:28 PM
Replies: 7
Views: 754
Posted By WeirdKooKy

another

picture
Forum: RC Monster Trucks
01-02-2003, 05:35 AM
Replies: 21
Views: 1,414
Posted By WeirdKooKy

SAVAGE Fule Problem

Yea, I know what you mean, the low end needles seem to go in forever. When the screw head of the needle is flush with the carb. body it is about 3 and 1/2 turns out from seat. It should stop...
Forum: RC Monster Trucks
01-01-2003, 03:10 AM
Replies: 21
Views: 1,414
Posted By WeirdKooKy

SAVAGE Fule Problem

hmmm... Well, blubery I guess is a bit hard to explain. What I'm trying to explain is that when you run the engine too rich it looses power and makes a sound that sort of sounds like it is spitting...
Forum: RC Monster Trucks
12-31-2002, 11:15 PM
Replies: 21
Views: 1,414
Posted By WeirdKooKy

SAVAGE Fule Problem

The tube going to the exhaust pipe from the engine is called the header. Just use the stock header on the Savage and the stock rubber coupler that connects the header to the pipe. Remove the...
Forum: RC Monster Trucks
12-31-2002, 03:24 PM
Replies: 21
Views: 1,414
Posted By WeirdKooKy

SAVAGE Fule Problem

Here is a link for an Ofna pipe that I have and it works very well: http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXBZY9&P=7 . At $18.39 it's the best deal that I've seen anywhere for an aluminum...
Forum: RC Monster Trucks
12-31-2002, 03:40 AM
Replies: 21
Views: 1,414
Posted By WeirdKooKy

SAVAGE Fule Problem

Well, the no.8 plug is a general use plug, not a cold plug like you should use. As far as the slow exceleration goes, it could be either rich or lean. The way to find out is to pinch the fuel line...
Forum: RC Monster Trucks
12-30-2002, 10:29 PM
Replies: 21
Views: 1,414
Posted By WeirdKooKy

SAVAGE Fule Problem

The throttle only opening 3/4th of the way is because of the throttle return spring, remove it and you'll see what I mean. I wouldn't recomend running the truck without a throttle return spring, but...
Forum: RC Monster Trucks
12-30-2002, 02:48 PM
Replies: 21
Views: 1,414
Posted By WeirdKooKy

SAVAGE Fule Problem

You haven't really caused your engine any damage, but over time it could. I've overheated my OS RG several times with no major consiquence, it's actually kind of good that the egine stops running...
Forum: RC Monster Trucks
12-29-2002, 06:14 AM
Replies: 28
Views: 1,759
Posted By WeirdKooKy

Is it ok to run savage 21 on sand?

Plastic board???
Forum: RC Monster Trucks
12-29-2002, 04:26 AM
Replies: 28
Views: 1,759
Posted By WeirdKooKy

Is it ok to run savage 21 on sand?

Not to be too technicial here, but sand is abrasive not corrosive. The finer the dirt the more places it can go and act abrasive on parts, that's why you should clean your bearings once and a while....
Forum: RC Monster Trucks
12-28-2002, 10:12 PM
Replies: 22
Views: 1,871
Posted By WeirdKooKy

dominator/thunder quake

Try using a blow dryer to warm it up, and then when you get it running you can adjust it from there. Normally needles are adjusted 3 turns out from seat. Here's a really dumb question, how is the...
Forum: RC Monster Trucks
12-28-2002, 03:09 AM
Replies: 22
Views: 1,871
Posted By WeirdKooKy

dominator/thunder quake

I have the Monster Pirate and I agree that it handles better at higher speeds than other monster trucks (ie. T-maxx and Savage) but those trucks are better for crawling. The Duratrax Torq .21 is...
Forum: RC Monster Trucks
12-28-2002, 12:13 AM
Replies: 3
Views: 533
Posted By WeirdKooKy

crash_me_over are you that crash_and_burn?

You da man! Those are some sweat prices! :stupid: :D
Forum: RC Monster Trucks
12-28-2002, 12:07 AM
Replies: 21
Views: 1,414
Posted By WeirdKooKy

SAVAGE Fule Problem

What's new?
Forum: RC Monster Trucks
12-28-2002, 12:01 AM
Replies: 28
Views: 1,759
Posted By WeirdKooKy

Is it ok to run savage 21 on sand?

You definately want to get a two stage air filter, one grain of sand can kill your engine. You also may consider using silicone to seal the bottoms of the diff. housings, goto...
Forum: RC Monster Trucks
12-27-2002, 11:48 PM
Replies: 22
Views: 1,871
Posted By WeirdKooKy

dominator/thunder quake

I never thought I would ever say this after owning a Duratrax Maximum ST, but I think that Thunder Quake is pretty cool. The two speed forward and reverse is nice and sounds like it is well built,...
Forum: RC Monster Trucks
12-27-2002, 11:38 PM
Replies: 1
Views: 633
Posted By WeirdKooKy

most powerful .21 PS engine...

The Hyper 8-port at www.ultimatehobbies.com for $119.95 is a steal and about the best pull start engine you'll find, especially for that price! Make sure you get the 8-port and not the standard...
Forum: RC Car General Discussions
12-27-2002, 06:27 AM
Replies: 12
Views: 961
Posted By WeirdKooKy

Everyone likes neat pictures, here's some pictures.

I would have to say that PC is stronger than stock plastic parts for the most part, of course that depending on the manufacture of the part. As far as the PC spliting, that sounds more like how it...
Forum: RC Monster Trucks
12-26-2002, 04:20 PM
Replies: 21
Views: 1,414
Posted By WeirdKooKy

SAVAGE Fule Problem

Did it fix it?
Forum: RC Monster Trucks
12-25-2002, 02:54 AM
Replies: 21
Views: 1,414
Posted By WeirdKooKy

SAVAGE Fule Problem

O.K. here is your problem, it's called hydrolock. What this means is that the engine is overheating and because the carburator is part of the engine, the heat passes on to the carb. Once the carb....
Forum: RC Car General Discussions
12-21-2002, 02:00 PM
Replies: 12
Views: 961
Posted By WeirdKooKy

Everyone likes neat pictures, here's some pictures.

If your car/truck is clean, you don't drive it hard enough, LOL! My buggy is about 2 1/2 years old, that's about as clean as it gets! I got the plastic from a plastic manufacture, the guy was super...
Forum: RC Car General Discussions
12-21-2002, 05:26 AM
Replies: 12
Views: 961
Posted By WeirdKooKy

Everyone likes neat pictures, here's some pictures.

It's not really hard at all, it reminds me of plexi-glass except it's properties are very much different. I just used a jigsaw with a scroll blade to cut it. The neat thing about Lexan is that it...
Showing results 1 to 25 of 36
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.