RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: lotech
Showing results 1 to 25 of 52
Search took 0.33 seconds.
Forum: Futaba Radios Direct support forum
07-10-2009, 07:46 PM
Replies: 2
Views: 642
Posted By lotech

RE: Rudder to Aileron mix w/elevons on

Thank You Bax for the speedy reply !

Now I get it ! :D
Forum: Futaba Radios Direct support forum
07-09-2009, 12:21 AM
Replies: 2
Views: 642
Posted By lotech

Rudder to Aileron mix w/elevons on

I've been trying to find this for a while. (plane) Yardbird prop-jet, no rudder servo.

I go to rud-ail default mix (p-mix 6 on the cap9super,5 on the super) . It makes no difference the rudder...
Forum: Twin & Multi Engine RC Aircraft
05-27-2009, 05:55 PM
Replies: 1,769
Views: 396,157
Posted By lotech

RE: DeHavilland Mosquito

David,
I used Chemtool carb spray on a rag to remove the lettering on the underside of my wing on my CMP warhawk.
It didn't hurt the paint at all and it took all of the residue off rapidly.
Hope...
Forum: Gas Engines
10-09-2008, 12:33 AM
Replies: 880
Views: 122,574
Posted By lotech

RE: New SV Gassers

We flew the FTL26 on the corsair tonite!!!

The plane weighs 12.86 Lbs. It was great for a engine that's not broken in yet!!

not awesome,but my friend insisted on a 14x9 3 blade on a new...
Forum: Gas Engines
10-09-2008, 12:21 AM
Replies: 880
Views: 122,574
Posted By lotech

RE: New SV Gassers

sorry charlie, but tell me how the Q improves??? service ,yes.

And these "cheap" engines are not "junk"(did I read you wrong?)

"cheap" yes.....
Forum: Gas Engines
10-08-2008, 01:51 PM
Replies: 880
Views: 122,574
Posted By lotech

RE: New SV Gassers

Hello Sam,

Is the service from them better?



Also we didn't get the corsair running last night [&o]

My friend forgot to charge the battery [:@]
Forum: Gas Engines
10-07-2008, 04:47 PM
Replies: 880
Views: 122,574
Posted By lotech

RE: New SV Gassers

hello again.

hobby city now offers the FTL 26 !

we have one and are planning on flying today with it in a KMP corsair.

I'll let you guys know how that goes.

It is a little more...
Forum: Extreme Speed Prop Planes
09-30-2008, 07:09 PM
Replies: 1,919
Views: 278,243
Posted By lotech

RE: THE NEW CERMARK F-16 BUILD IT BETTER, STRONGER, AND FASTER!!!

:) whew , just got done reading up on all of the old posts ! (tons of good advice) thanks to all who contributed ! :D

now I'll start my build .

btw I also have the first version W/ OS 60...
Forum: Gas Engines
09-25-2008, 01:38 AM
Replies: 880
Views: 122,574
Posted By lotech

RE: New SV Gassers

Andre, the #1 is to put pressure to the tank on weedeaters, plug it. #2 is for the fuel line from the tank!!! If you start this engine with a electric starter you will have no problems when cold

...
Forum: Extreme Speed Prop Planes
09-24-2008, 07:46 PM
Replies: 1,919
Views: 278,243
Posted By lotech

RE: THE NEW CERMARK F-16 BUILD IT BETTER, STRONGER, AND FASTER!!!

hello everyone!! I just received my thunderbird version saturday. Looks like I have some reading to do. LOL
Mine is from cermarks latest batch and the C/G is still listed as 8 1/2 inches!!!!
...
Forum: Gas Engines
09-12-2008, 07:43 PM
Replies: 880
Views: 122,574
Posted By lotech

RE: New SV Gassers

dummy meLOL I didn't read that ya had the PT-17!!!! duh on me!!!

the timing really helps on these engines, GOOD luck, and tnx!!!!
Forum: Gas Engines
09-12-2008, 01:08 PM
Replies: 880
Views: 122,574
Posted By lotech

RE: New SV Gassers

at your elevation you probably won't.I live at about 200' el. also timing is critical on these nice little engines!

my stearman was weighed on pro scale at just under 17 Lbs.,has yours been...
Forum: Gas Engines
09-11-2008, 10:48 PM
Replies: 880
Views: 122,574
Posted By lotech

RE: New SV Gassers

It will have plenty of reserve power!!

this plane only weighs in the 10Lb range and they rated it for too big of an engine.

both sv26's will turn a 16x8 prop at about 9000, as does my os...
Forum: Gas Engines
09-11-2008, 02:23 PM
Replies: 880
Views: 122,574
Posted By lotech

RE: New SV Gassers

I have the cmp 73" with a 120 ax os. flies very well and fast. 10.5 Lbs.
I also have the sv 26 in a great planes super stearman 17 Lbs flies well.

so I am sure that the sv 26 would be great...
Forum: Gas Engines
09-02-2008, 10:52 PM
Replies: 880
Views: 122,574
Posted By lotech

RE: New SV Gassers

sorry that I forgot about one of my prior posts! On the 26 there is a side plate on the cylinder,I've found that gasket to leak and cause nonadjustable carbs also!!!!
check there before the carb...
Forum: Gas Engines
09-01-2008, 11:30 PM
Replies: 880
Views: 122,574
Posted By lotech

RE: New SV Gassers

ratchet,those basic settings don't work alot with sv,try rich on the hi speed then adj.low,then go back to hi,if that doesn't help,I check this thread every day there is a new post!!

tommy,I...
Forum: Gas Engines
09-01-2008, 07:52 PM
Replies: 880
Views: 122,574
Posted By lotech

RE: New SV Gassers

ratchet,which needle are you adjusting???
and 30:1 is a little much oil for these
Forum: Gas Engines
08-30-2008, 11:12 PM
Replies: 880
Views: 122,574
Posted By lotech

RE: New SV Gassers

Yep, that's it.
Forum: Gas Engines
08-29-2008, 02:54 PM
Replies: 880
Views: 122,574
Posted By lotech

RE: New SV Gassers

hello new225,
in post #750 here you will find the web address for rcshowcase,thy should have the reed petals you need.
hope this helps,
lotech
Forum: Twin & Multi Engine RC Aircraft
08-22-2008, 08:55 PM
Replies: 1,769
Views: 396,157
Posted By lotech

RE: DeHavilland Mosquito

I run 4 strokes a lot,4-5"pitch are fine for light wingloads(low)speeds,lots of thrust.
but,for a plane that has high wingloading,you need to prop for higher speed.
If you check back on this...
Forum: Twin & Multi Engine RC Aircraft
07-14-2008, 07:38 PM
Replies: 1,769
Views: 396,157
Posted By lotech

RE: DeHavilland Mosquito

:D So far for me,nice to have.I just got mine a few weeks ago
and i'm still looking for some spinners at a reasonable cost.
got retracts,OS 52 FS's,and all other gear to go,now just need time
...
Forum: Gas Engines
07-14-2008, 07:10 PM
Replies: 880
Views: 122,574
Posted By lotech

RE: New SV Gassers

:)David,
Thank you for telling all of us.I'm sure it will help many,
as most sites don't show any parts for these good little engines.
I've been a mechanic over 36 yrs.and airplane hobbist...
Forum: Gas Engines
07-11-2008, 07:16 PM
Replies: 880
Views: 122,574
Posted By lotech

RE: New SV Gassers

I,just found rc showcase yesterday,went there and could'nt find parts listing.
I am exteremly new to web,so I might have missed(link)?but if I would have
found parts I was coming back here to...
Forum: Gas Engines
07-09-2008, 01:40 PM
Replies: 880
Views: 122,574
Posted By lotech

RE: New SV Gassers

Hello,I just got free's SV and made new gaskets for it we've not found any
reliable source for any parts on these.I even had to make reeds for one
friend,used motorcycle reeds and cut them to...
Forum: RC Warbirds and Warplanes
07-03-2008, 08:39 PM
Replies: 345
Views: 53,886
Posted By lotech

RE: 1/8 scale functional Hamilton Standard hub for RCV SP engines.

Hello Josh, My Name is Bruce.I read through this forum today and am
truly impressed!I'm into warbirds altho not corsairs.I thougt I would
update you on Paradice,Ca.,I live 40 miles NW of...
Showing results 1 to 25 of 52
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.