RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: angelwings
Showing results 1 to 6 of 6
Search took 0.63 seconds.
Forum: RC Jets
05-16-2016, 10:10 PM
Replies: 9
Views: 4,432
Posted By angelwings

Can someone tell me how well this unit works on...

Can someone tell me how well this unit works on other airplanes or is it just for jets? I fly 35% and 40% gas airplanes(Extra2650, 300, Sbach, etc.), and would like to hear more about this unit...
Forum: ARF or RTF
03-19-2003, 06:08 AM
Replies: 12
Views: 2,296
Posted By angelwings

Hangar 9 P-51 Landing Gear (JUNK!)

The stock gear DOES have a set screw to hold the "legs" in. I'm like everyone else. I had all sorts of problems with the "stock" gear. I replaced them with Robarts and not one single problem after...
Forum: RC Warbirds and Warplanes
03-19-2003, 05:36 AM
Replies: 9
Views: 900
Posted By angelwings

H9 P-51 Propsize

Absolutely correct on the 14" prop. I have two of them and 14" props are the way to go. I tried a smaller 11" four-bladed one and "ugh". Not enough power, etc. until I went back to the 14" prop. ...
Forum: RC Warbirds and Warplanes
01-23-2003, 06:52 PM
Replies: 5
Views: 749
Posted By angelwings

h9 p51 ??help??

You're a senior? Sounds like you're "flunking" in the CS (common sense) category!! The school yard is not the place to fly!! ESPECIALLY a new ship that you're not even familiar with. It's a super...
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
01-23-2003, 06:08 PM
Replies: 5
Views: 1,314
Posted By angelwings

Wow!!! Check This Out!!!

Well, here's my 3c as I've had the same problem.

1. Check the rod in the starter itself. If it seems "hot", that means that the adapter end of the starter is turning, but the rod is...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-22-2003, 07:25 AM
Replies: 1
Views: 667
Posted By angelwings

adapt retract servo from rotary to linear output

I would like to find a servo adapter, such as a pair of toothed tracks that fit on each side of the servo spline, so that as the spline turns, the tracks move in a linear motion, thereby providing...
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.