RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: E.Banner
Showing results 1 to 25 of 33
Search took 0.63 seconds.
Forum: RC Jets
07-26-2007, 10:24 AM
Replies: 4,015
Views: 673,706
Posted By E.Banner

RE: Nitro models pusher Bobcat?

Hi Xairflyer,

Not flown it yet but I’ve set spoilerons as GSK recommends. These will through increased drag reduce speed as well as reducing lift. I’ve used spoilerons on previous planes...
Forum: RC Jets
07-23-2007, 10:04 AM
Replies: 1,429
Views: 323,177
Posted By E.Banner

RE: Jetlegend T-45 Hawk

Hi Guys,

Please note that the current production fuse is somewhat lighter than the one I reviewed in RCJI.
Perhaps someone with a new kit could weigh the fuse?

Eric
Forum: RC Jets
07-23-2007, 02:47 AM
Replies: 5,088
Views: 1,236,959
Posted By E.Banner

RE: Bob Cat Copy Falcon 120 Jet

Hi MattyC-130,

Steve used HS225's on elevators and JR811's on ailerons and flaps.

Eric
Forum: RC Jets
07-18-2007, 02:06 AM
Replies: 1,429
Views: 323,177
Posted By E.Banner

RE: Jetlegend T-45 Hawk

Hi Jase,

Yes, I’m flying my T45 with the tailpipe/turbine set as in the pictures. I have approx 100 flights on her now. The pipe incidence effect (if any) is not a problem or even noticeable....
Forum: RC Jets
07-09-2007, 04:43 AM
Replies: 225
Views: 68,866
Posted By E.Banner

RE: JetLegend F-16 (1/8) Testflight

Hi ubirajaramarques,

Attached is a sketch of system using Jetronics valve and micro-switch. Well, at least one way of doing it...

Eric
Forum: RC Jets
07-03-2007, 05:55 AM
Replies: 225
Views: 68,866
Posted By E.Banner

RE: JetLegend F-16 (1/8) Testflight

Hi Ubirajaramarques,

Had a similar problem which I eventually cured by lubricating the main cylinder, internally, with a little thick Silicon grease. A drop or two of very thin silicon lubricant...
Forum: RC Jets
06-19-2007, 08:03 AM
Replies: 1,429
Views: 323,177
Posted By E.Banner

RE: Jetlegend T-45 Hawk

Hi Nicola,

We need someone who's actually tried a T45 off grass to comment.

If the grass is short, the ground dry and hard I would imagine 18.4 lbf would get the T-45 airborne.

I have...
Forum: RC Jets
06-19-2007, 02:56 AM
Replies: 225
Views: 68,866
Posted By E.Banner

RE: JetLegend F-16 (1/8) Testflight

Hi ubirajaramarques,

I’ve no actual experience of the JL F-16 off grass and only 4 flights off tarmac so far...

With the MW54 on tarmac the acceleration is rapid and the take off run...
Forum: RC Jets
05-02-2007, 05:00 AM
Replies: 802
Views: 144,353
Posted By E.Banner

RE: FOX COMPOSITES Bae HAWK, Build thread

Hi Paul,

The wingspan advertised on Jim's website is 53". Do you know the span of the optional "Sport wing"?

Best regards,
Eric
Forum: RC Jets
03-29-2007, 08:18 AM
Replies: 16
Views: 2,133
Posted By E.Banner

RE: Elev Servo Flutter on T45

Hi Pantherman,

Here’s what I would do:

Temporally tape 2oz to the leading edge of each elevator half.

At rest and when the elevator stick is moved:
If the buzzing has stopped...
Forum: RC Jets
03-14-2007, 07:32 AM
Replies: 1,429
Views: 323,177
Posted By E.Banner

RE: Jetlegend T-45 Hawk

Hi Jonathan,

The kit “cube” tank at 2.75 litre capacity is fine. The tank is some 6 to 8” in front of the dry c of g (full UAT counts as dry) at 120mm.

A full tank obviously puts the...
Forum: RC Jets
03-14-2007, 05:34 AM
Replies: 1,429
Views: 323,177
Posted By E.Banner

RE: Jetlegend T-45 Hawk

Hi wing13

I'd recommend you balance level at 120 mm back from the LE at wing centre.

Eric
Forum: RC Jets
02-13-2007, 09:31 AM
Replies: 41
Views: 6,868
Posted By E.Banner

RE: Plumbing Two tanks in my Hawk

Hi Dennis,

My 2p's worth:

Plumb tanks in series using plain metal clunks. Use a proper BVM UAT not a central pickup header (everybody’s mileage varies!).

Include a BVM or Festo...
Forum: RC Jets
01-29-2007, 08:48 AM
Replies: 1,429
Views: 323,177
Posted By E.Banner

RE: Jetlegend T-45 Hawk

Hi jwsp69,

Only a couple of more flights so far. Both the plane and the Super Bee are performing very well, both in terms of power and reliability.

I’ve recently been distracted playing...
Forum: RC Jets
01-26-2007, 06:34 AM
Replies: 109
Views: 16,182
Posted By E.Banner

RE: JR 2.4 gig radios

Don't push your luck Trevor:D

Eric
Forum: RC Jets
01-17-2007, 04:49 AM
Replies: 109
Views: 16,182
Posted By E.Banner

RE: JR 2.4 gig radios

Hi Trevor,

The scenario that Dave S paints, taken together with flying at an active military base don’t fill me with joy! The planes behaviour during the second and third flight did smack of...
Forum: RC Jets
01-16-2007, 03:42 AM
Replies: 109
Views: 16,182
Posted By E.Banner

RE: JR 2.4 gig radios

Hi Flying Arrow

The separation distance that I have now between the receivers and the rest of the install must surely be OTT.

I’m beginning to feel that the main issue is the relative...
Forum: RC Jets
01-16-2007, 03:22 AM
Replies: 109
Views: 16,182
Posted By E.Banner

RE: JR 2.4 gig radios

Hi Dave,

Yes it is. My Futaba Rx was fixed at a similar distance from ECU without any range or interference issues.

Eric
Forum: RC Jets
12-12-2006, 09:02 AM
Replies: 19
Views: 2,607
Posted By E.Banner

RE: Turbine for Skymaster F-16 1/8

Hi Robert,

A Jet Central Super Bee in the tail is worthy of consideration.

Check out:

http://www.jetsrc.com/videos/F-16_18_JetsRC.wmv

Regards,
Eric
Forum: RC Jets
11-14-2006, 07:54 AM
Replies: 39
Views: 5,606
Posted By E.Banner

RE: Wren54 MKIII kit, What is your impression?

Hi Ehab,

Last year I had the pleasure of reviewing an MW54 Mk3 for RCJI. I would unreservedly recommend the engine.

Build is straightforward and the turbine can be ready to run in 3 to 4...
Forum: RC Jets
11-03-2006, 05:39 AM
Replies: 22
Views: 4,778
Posted By E.Banner

RE: AMD BAe Hawk - Gutted

Hi Nick,

Sorry to hear about your mishap with the Hawk. I hope the damage dosent look so bad in a day or two!

As you said my maiden with the AMD Hawk necessitated full up elevator.

...
Forum: RC Jets
10-05-2006, 07:39 PM
Replies: 764
Views: 88,639
Posted By E.Banner

RE: Jetlegend T45

Nice try Dominic!

I'm sure you’d have made it too if the turbine had behaved itself.

Kind regards,
Eric
Forum: RC Jets
09-15-2006, 02:36 AM
Replies: 764
Views: 88,639
Posted By E.Banner

RE: Jetlegend T45

Thanks Jose.


Eric
Forum: RC Jets
01-25-2006, 08:32 AM
Replies: 65
Views: 6,175
Posted By E.Banner

RE: Worrying trend or coincidence....

_____________________________
Hi Treadstone22,

There are others on this forum who are qualified to answer this question, I’m not. However, having got the disclaimer out of the way, lets have...
Forum: RC Jets
01-16-2006, 08:16 AM
Replies: 132
Views: 11,717
Posted By E.Banner

RE: UK JET NUTS {Bentwaters 2006}

Count me in please Graham.

Eric Banner
SNMFC Scorpions
Showing results 1 to 25 of 33
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.