RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: hirst_cb
Showing results 1 to 25 of 36
Search took 0.62 seconds.
Forum: Traxxas Monster Truck forum
04-15-2005, 01:22 PM
Replies: 0
Views: 404
Posted By hirst_cb

Phantom .18 motor pr18

I just got this motor used, it was said to just been tuned..... I cant seem to find anything on this motor on the web and cant get the motor to start... If I was to screw the adjustment screw...
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
04-06-2005, 06:06 PM
Replies: 0
Views: 793
Posted By hirst_cb

XTM Racing Xcellerator electric 1/10 scale 2wd stadium truck

What info do you guys have about the XTM Racing Xcellerator electric 1/10 scale 2wd stadium truck. I know about most of them but havent seen much on this truck. How is the electric truck comparted...
Forum: RC Helicopter Beginners Forum
03-21-2004, 11:07 PM
Replies: 2
Views: 487
Posted By hirst_cb

RE: buying over internet?

Hey, I buy used alot from ebay and yahoo but I mostly only buy things that are available for purchase with paypal and if I am paying alot I use the guarantee program that you can purchase for alittle...
Forum: RC Helicopter General Discussions
03-21-2004, 06:57 PM
Replies: 6
Views: 764
Posted By hirst_cb

RE: Better transmitter for Raptor 30

thanks guys - I just bought a Hitec 7 Eclipse today - I know what I will be doing for the next couple of nights - setting it up!!
Forum: RC Helicopter General Discussions
03-20-2004, 12:25 PM
Replies: 6
Views: 764
Posted By hirst_cb

Better transmitter for Raptor 30

Hi all!!!! which is a better transmitter for a Raptor 30 - A Hi-tec Eclipse 7, or Fuataba 8UAP - I would like to get a futaba 9c but dont want to spend to $300-$400 right now. I can get the 1st...
Forum: RC Helicopter Beginners Forum
03-19-2004, 02:13 PM
Replies: 2
Views: 330
Posted By hirst_cb

RE: Is this a good buy for a Raptor 30 V1

Man!!!! no one has any suggestions or opionions??
Forum: RC Helicopter Beginners Forum
03-18-2004, 10:10 PM
Replies: 2
Views: 330
Posted By hirst_cb

Is this a good buy for a Raptor 30 V1

THIS IS A RAPTOR 30 V1 WITH ONLY 2 TANKS OF FUEL ON THE AIR FRAME AND ELECTRONICS. A guy down the road is selling a Raptor V1 30 with 4 NEW FUTABA 3004 AND HITEC HIGH SPEED ON TAIL. IT HAS A 1100MAH...
Forum: RC Helicopter Beginners Forum
03-18-2004, 04:58 PM
Replies: 5
Views: 600
Posted By hirst_cb

RE: WHAT IS A GOOD STARTER HELI!!!

hi, is the raptor 30 V1 good - whats the difference between the V1 and V2. whats a good price for a V1 minus radio with everything else. thanks
Forum: RC Helicopter Beginners Forum
03-18-2004, 02:09 PM
Replies: 5
Views: 600
Posted By hirst_cb

WHAT IS A GOOD STARTER HELI!!!

Hi, ive been flying r/c planes and want to get a copter. not that it will help all that much - Id like to get some opinions on which Heli is good to start with and be able to do some tricks with it...
Forum: Beginners
03-11-2004, 10:56 PM
Replies: 6
Views: 414
Posted By hirst_cb

RE: Can anyone use a AM 72.230 transmitter

JTorres - appreciate the site - alot of info to soak in but it was well worth it. thanks
Forum: Beginners
03-11-2004, 07:39 PM
Replies: 41
Views: 2,993
Posted By hirst_cb

RE: E-BAY

:D I use ebay all the time - I have bought cars on it, fish tanks and equipment, jewlry, and a couple of airplanes and equipment - like others said - know what to pay and what not to pay. sometimes...
Forum: Beginners
03-11-2004, 07:21 PM
Replies: 6
Views: 414
Posted By hirst_cb

Can anyone use a AM 72.230 transmitter

Hi, my question is - can anyone use a AM transmitter and what is the difference between using FM verse AM transmitters - is the FM more reliable or better to use.:D
Forum: Beginners
03-07-2004, 01:32 AM
Replies: 11
Views: 1,037
Posted By hirst_cb

RE: OS Max 40 that I cant get to idle

thanks guys for the info - I never got a chance today to adjust the carb(forgot to charge igniter battery) will try tomorrow - the picture was perfect could see everything and that is what it looks...
Forum: Beginners
03-06-2004, 02:56 PM
Replies: 11
Views: 1,037
Posted By hirst_cb

RE: OS Max 40 that I cant get to idle

Hi, I tried to upload picture but it is not supported it says. I'll describe it - os max sf 40 - as your looking at the engine - has the large needle(highend- right), low end screw on right side at...
Forum: Beginners
03-06-2004, 12:23 AM
Replies: 11
Views: 1,037
Posted By hirst_cb

RE: OS Max 40 that I cant get to idle

thanks for replying - I turn it counter clockwise to richen it. I stated by closing the needle valve and turned it two turns out - when i try to idle it back from almost full throttle i can go about...
Forum: Beginners
03-05-2004, 08:34 PM
Replies: 11
Views: 1,037
Posted By hirst_cb

OS Max 40 that I cant get to idle

Hi all - I have a OS Max 40 that I cant get to run when I lower the throttle below 60%. Runs great until I try to dial her down. I tried adjusting the needle valve both ways a turn or so but not...
Forum: Beginners
02-28-2004, 11:25 PM
Replies: 11
Views: 671
Posted By hirst_cb

RE: Starting the engine

Oh yeah forgot one thing - I have used liquid wrench and even soaked it in it. Didnt do a thing. The engine and all parts look very clean - even looking in the hole where the carb went is clean and...
Forum: Beginners
02-28-2004, 11:23 PM
Replies: 11
Views: 671
Posted By hirst_cb

RE: Starting the engine

Thanks for replying - I was thinking about putting the carb in the oven. I took off the O-ring on the bottom, the needle valve - throttle assembly - Is there any other things I cant see in the carb...
Forum: Beginners
02-28-2004, 08:42 PM
Replies: 11
Views: 671
Posted By hirst_cb

RE: Starting the engine

It is stuck at the carb - I have it off the engine now and I am using some stuff to break rust and etc. It still isnt coming loose. the throttle keeps slipping against the medal - I keep tightening...
Forum: Beginners
02-28-2004, 07:39 PM
Replies: 11
Views: 671
Posted By hirst_cb

RE: Starting the engine

The motor is a OS Max sf 40 - I have a os fx 60 that im trying to get the throttle unstuck - havent had luck yet - will I have to take it apart or is there a better way - I put gas in there but it...
Forum: Beginners
02-28-2004, 07:37 PM
Replies: 11
Views: 671
Posted By hirst_cb

RE: Starting the engine

I'll check that - I got it started with a different igniter but I only let it charge for about 45 minutes I dont think it lasted long - the engine started twice for about 10 seconds then died. I...
Forum: Beginners
02-28-2004, 06:58 PM
Replies: 11
Views: 671
Posted By hirst_cb

Starting the engine

Hi, I got my throttle unstuck today. Filled it up with gas and put a new glow plug in it. I hooked up the igniter from my 12 volt battery. I think its working - it gave alittle spark when I first...
Forum: Beginners
02-28-2004, 06:47 PM
Replies: 16
Views: 826
Posted By hirst_cb

RE: Fuel filling

Ok, thanks - I filled it up and no spills and the over flow cup worked good.
Forum: The Clubhouse
02-28-2004, 06:43 PM
Replies: 8
Views: 588
Posted By hirst_cb

RE: Clubs in Orlando

Ok, thanks - Is it an open field or a club? What kind of fees.
Forum: Beginners
02-28-2004, 04:37 PM
Replies: 16
Views: 826
Posted By hirst_cb

Fuel filling

I have an electric pump - does anyone have any quick tips for making the job fast, easy and spill proof. I havent tried yet but I figured I would put it out there first. Thanks for all the replys...
Showing results 1 to 25 of 36
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.