RCU Forums - Search Results

Search: Posts Made By: EyeflyRC

Showing results 1 to 6 of 6
Search took 0.10 seconds.

Forum: Glow Engines

07-04-2018, 03:40 PM

Replies: 988

OS engines users Club

Views: 180,513

Posted By EyeflyRC

If you cannot find the original retention screw,...

If you cannot find the original retention screw, consider making your own. Buy a screw with the same thread and diameter at the hardware store and use a hand file to reduce 3/16" of the end of the...

Forum: Glow Engines

10-26-2011, 02:29 AM

Replies: 988

OS engines users Club

Views: 180,513

Posted By EyeflyRC

RE: OS engines users Club

Niedm,
If the ring was properly installed the castor oil should have sealed the ring enough to start the engine even if you did not clean the glaze off the cylinder walls. If you tried starting it...

Forum: Glow Engines

10-24-2011, 01:13 AM

Replies: 988

OS engines users Club

Views: 180,513

Posted By EyeflyRC

RE: OS engines users Club

Put a few drops of castor oil in the cylinder through the glow plug hole and check to see if this brings up the compression to normal. If it does, the ring probably has not seated in the cylinder,
...

Forum: Glow Engines

10-23-2011, 09:06 AM

Replies: 988

OS engines users Club

Views: 180,513

Posted By EyeflyRC

RE: OS engines users Club

Landeck. Now that I think about it, I had that engine in a Venus 40 that I crashed due to pilot error some time ago. It was on the third flight of the Ultra Stick 40 when the seal blew. Perhaps it...

Forum: Glow Engines

10-23-2011, 06:16 AM

Replies: 988

OS engines users Club

Views: 180,513

Posted By EyeflyRC

RE: OS engines users Club

OS 46 AX engine problem. Yesterday I flew my Hanger 9 Ultra Stick 40 with a side mounted OS 46 AX that I bought used but in good condition. The engine ran fine in the air but when I landed it flamed...

Forum: Glow Engines

06-16-2007, 08:23 PM

Replies: 988

OS engines users Club

Views: 180,513

Posted By EyeflyRC

RE: OS engines users Club

Waco Driver,

I noticed you have an OS 80 H R/C. I just recently purchased a new one and was wondering how you like yours. What is the best combination of prop and fuel for this beauty?

...

Showing results 1 to 6 of 6