RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: JS440
Showing results 1 to 7 of 7
Search took 0.01 seconds.
Forum: Speed - RC Nitro Boats
12-22-2021, 08:55 AM
Replies: 53
Views: 6,028
Posted By JS440

I'm usually a 120/220/320 kinda guy, sometimes...

I'm usually a 120/220/320 kinda guy, sometimes going up to 400, often skipping 120. I usually have a few others in the shop, but those are the 4 grits I ALWAYS have on hand.
Forum: Speed - RC Nitro Boats
12-21-2021, 12:47 PM
Replies: 53
Views: 6,028
Posted By JS440

For sealing and paint, I'd suggest sealing with...

For sealing and paint, I'd suggest sealing with epoxy fiberglass resin (thinned if you'd like to save a bit of weight). I've used epoxy paints before, and while it's possible to get a good finish, to...
Forum: Speed - RC Nitro Boats
12-20-2021, 02:12 PM
Replies: 53
Views: 6,028
Posted By JS440

https://www.mcmaster.com/tubing/plastic-and-rubber...

https://www.mcmaster.com/tubing/plastic-and-rubber-tubing-for-flow/high-temperature-soft-rubber-tubing-for-air-and-water/id~5-16/

That's a list of high temp hose with a 5/16" ID, note prices are...
Forum: Speed - RC Nitro Boats
12-20-2021, 01:33 PM
Replies: 53
Views: 6,028
Posted By JS440

Hydro, obviously you need air intake and exhaust,...

Hydro, obviously you need air intake and exhaust, but WHERE that air enters and exits is important. Whenever possible I like to have my cowl fairly well sealed against the hull, so that if it dies on...
Forum: Speed - RC Nitro Boats
12-20-2021, 10:49 AM
Replies: 53
Views: 6,028
Posted By JS440

If you can measure the OD of the exhaust outlets...

If you can measure the OD of the exhaust outlets you should be able to find the right size silicone hose online. McMaster Carr is always a safe bet, but expect to spend a bit of $ on shipping. Having...
Forum: Speed - RC Nitro Boats
12-20-2021, 08:31 AM
Replies: 53
Views: 6,028
Posted By JS440

In/out on the head doesn't matter. If one of the...

In/out on the head doesn't matter. If one of the nipples were lower than the other, that one would be in, and the upper one would be out. Yours are at the same height, so you can use whichever is...
Forum: Speed - RC Nitro Boats
12-19-2021, 03:48 PM
Replies: 53
Views: 6,028
Posted By JS440

The nipple on the muffler should run to your fuel...

The nipple on the muffler should run to your fuel tank to provide positive pressure to feed fuel to the carb.

Also, that tubing on the exhaust doesn't look like high-temp tubing, and could very...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.