RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: GREG DOE
Showing results 1 to 3 of 3
Search took 0.01 seconds.
Forum: Glow Engines
09-29-2021, 11:25 AM
Replies: 14
Views: 2,739
Posted By GREG DOE

Once again there is a reason why there is a hole...

Once again there is a reason why there is a hole through the prop nut, so that you don't have to use "channel lock pliers on them". He was probably just joking?
Forum: Glow Engines
09-28-2021, 06:38 PM
Replies: 14
Views: 2,739
Posted By GREG DOE

706jim said he used a 7/8" box wrench on a round...

706jim said he used a 7/8" box wrench on a round spinner nut? I guess he must file, or grind a hex pattern on them? The old Harry Higley safety prop nuts had a hex pattern, as well as a hole for a...
Forum: Glow Engines
09-27-2021, 09:01 PM
Replies: 14
Views: 2,739
Posted By GREG DOE

Good question if you haven't been there before....

Good question if you haven't been there before. First a good drill bit is too hard for this job, because it will snap and break before you get the spinner nut tight. My quickest go to tool is a allen...
Showing results 1 to 3 of 3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.