Smart-Fly (Quest Engineering) Support Forum Support forum for all Smart-Fly products. Equalizers, Batshare, Ignition Cutoff, Regulators.

Best setup?

Old 01-03-2012, 09:49 PM
Junior Member
Thread Starter
My Feedback: (1)
Join Date: Dec 2007
Location: sEMINOLE, TX
Posts: 20
Likes: 0
Received 0 Likes on 0 Posts
Default Best setup?

Hello, I want to use a dual redundant A123- 2300 battery setup to power my Futaba R617FS receiver (using all channels).
So, if I use the BatShare, what is the output voltage going to be?
Or, if I use the SmartFly Sport Reg, what should the output voltage be set at?
Which would be the best setup?
Old 01-04-2012, 06:20 AM
Senior Member
Join Date: Sep 2004
Location: Tempe, AZ
Posts: 949
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Best setup?

If you use a BatShare your servo voltage will be approximately 0.3V to 0.45V lower than the battery voltage depending on current load. If you use the SportReg you need to keep it set at 5.5V as there is approximately a 1V drop-out voltage of the regulator. You need to determine your best setup based on your servos too. Personally, I would use the PowerExpander Sport Plus to protect my investment.

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.