any news on the EQ10

Hi Adrian,
No good news I am afraid. The PCBs are taking 8 weeks instead of 5 weeks. We should start assembly on about the 8th of December. I am sorry about this but I am at the mercy of my suppliers. My PCB house really let me down on this one.

we have time - but we are looking forward to receiving ours - tx

Hi Adrian,
Sometimes this goes smooth and sometimes it doesn't. Just got unlucky this time but it will get done.

Robert

will you update the site once they arrive? Id like to buy one for an upcoming winter build

Hi,
It seems I overloaded my electronic assembler and they did not tell me. I have told them I have to have some of these by the AMA Convention 1/12. All I can do right now is hope they keep their word. If I had known that I was overloading this one assembler I would have used one of my other assemblers for this. Sorry.

news - sorry to ask??

Hi,
I am expecting a couple units today to verify production. The issue is that I have to leave tomorrow morning for the AMA 2007 Convention so I do not know if I can check these out until Monday. I am really sorry this is taking so long, there have just been a lot of gotchas on the way to production.

no problem, im sure these are worth the wait

Any chance I can get a 1st production run unit for my new build im doing?

I will announce on my Yahoo group when we get stock. I will probably have enough but I have to wait and see what I get in.