Turnigy 180 esc / program card issue
#1
Thread Starter
Join Date: Jan 2017
Posts: 329
Likes: 0
Received 0 Likes
on
0 Posts
Turnigy 180 esc / program card issue
I have a new Turnigy 180 amp marine esc plus a new matching Turnigy Program Card. trying to set the esc up with this card and it does not work, all i get on the card screen is 3 horizontal red lines , 2 lines in left screen and 1 line in right screen. anyone had this problem as i think it is a no go card. i am running a lipo pluged into the esc and the 3 pin plug rx wire goes into the card, so all is set right i think.
#2
Thread Starter
Join Date: Jan 2017
Posts: 329
Likes: 0
Received 0 Likes
on
0 Posts
All good now, silly me didn,t spot the 3 pins sticking out of the esc was using the long receiver wire into card instead of this 3 pin plug end. oh and i must put some blame on Turnigy for not supplying a decent up to date user set up manual.