So 2 sets of plans were ordered. 1 for me the other I had sent to MLBoatworks so Mike can develop the kit.:D


Regards
Hubert

Hi Guys,
I got the anti spark QS-8 connectors for the battery and esc They are nice and really tight on the interference fit. :cool: so ill solder up a pack and and configure the esc's telemetry with the XLX2 now.. Lets see how it goes. After we get all that figured out the gyros and other electronics and running hardware should be here . Then we will configure that. Its enuf to figure out.

Regards,
Huberthttps://cimg1.ibsrv.net/gimg/www.rcu...94ee376ac0.jpg

FYI about composite hulls... Oliver @ H&M says he does not have the work potential to realize this project. Whatever that means. Steve Gualtieri RC Boat Companys wing boat is modular. The center section and sponsons are built separate. So it can create this boat! The cowl; would need modification and the front canards need to be added..

Regards,
Hubert

The reason I settled on a wood kil from James is because he redesigns the tunnels for less flight. I know for a fact that an H&M will kite. Herb Sowden had the 4 wing Budd on a Plettenburg 50BM . It runs really fast but kites in the video just like a boat with a steep tunnel.. It seems impossible but having that huge wing right at the front of the boat obviously facilitates that even though the tunnel is virtually non existent. at every opening between the sponsion set and main body.. This is why I do not want the 2 wing Circus or Budd. The wing is a huge asymmetrical foil the faster you go the more it lifts. Having the wing at the cg theoretically lifts the entire boat at the cg. Like raising the see saw at the fulcrum. The you use the from canard and rear wing to make the kids on each end always the same weight. If you watch the boat run in its debut wou see the hull rocking froward an back centered on the main wing. Too much for a driver to pedal unless its drive by wire with macro functions. The reaction time is not there for a human so you try to keep the boat actively from that angle of attack at which the blow over is inevitable by using a computer system to monitor and control the flaps

The Three Wing Circus can begin...
 

Hi Fellas,

6 to 8 weeks on delivery for synergy. The carbon 3 wing starts as a modular lay of the sponson set and center section and cowl which ill modify from. RC Boat Company.. Ill have to really think about the rudder mounting on the hull .

SG92102.5H | My Site (rcboatcompany.com)

Here's his kit quality Christian.

Nice !