new boat
#3
Join Date: Feb 2006
Location: elkton,
MD
Posts: 3,657
Likes: 0
Received 0 Likes
on
0 Posts
RE: new boat
just right click on your web page at the top, then copy it. then in your post here, just right click in your post, then paste it. then your link should show up in your post
#6
My Feedback: (1)
RE: new boat
Patience there as you posted late last night and a lot of people haven't checked in here yet today.
The outdrive might be a Kanellos and it has Aeromarine trim tabs. What else you have there I don't know as it is some old stuff.
Greenville huh? I didn't notice your address until I spotted the Meijer's tub.
The outdrive might be a Kanellos and it has Aeromarine trim tabs. What else you have there I don't know as it is some old stuff.
Greenville huh? I didn't notice your address until I spotted the Meijer's tub.
#8
Junior Member
Join Date: Aug 2009
Location: Belleville, ON, CANADA
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
RE: new boat
That is identical to the boat I am just shipping to nieto 1124, mine had 2 outdrives with twin OS max 65s in it, maybee nieto can help you, he seems to no his stuff.
#9
My Feedback: (3)
RE: new boat
Cannot say the hull looks at all familiar. Hard to tell but from the pics it almost looks like someone has adapted the deck to accomodate the cowl. The profile certainly does not suit the hull.
Just by looking at the drive, power (may not be original but older none the less), and styling I would guess her to be a mid-late 1990's model.
Just by looking at the drive, power (may not be original but older none the less), and styling I would guess her to be a mid-late 1990's model.
#11
Member
Thread Starter
Join Date: Sep 2007
Location: greenville,
MI
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
RE: new boat
thanks to everyone. i only paid a 100.00 for it so im not out much. the motor runs good and it has a clutch on it. i am going to move the motor. they had it mounted on the very rear of the boat. it has all the electronics, i need a gas tank and a sealed box. the servos are not in anything. just mounted. it will be a good winter project.
#15
My Feedback: (3)
Join Date: Jun 2008
Location: Winterville,
NC
Posts: 183
Likes: 0
Received 0 Likes
on
0 Posts
That is an International Hobbies-Amps ICBM gas vee hull. It was suppose to be a loose representation of the Fountain ICBM offshore powerboat, but the cockpit is completely different than the real boats are . These were usually made in a red gel coat, however I have seen one that was white. Here is a photo of my original ICBM Enjoy, Mike, ML Boatworks