Nitro engine needed! Please help
09-09-2011 | 07:16 PM
#1
Thread Starter
Junior Member
My Feedback: (1)
Joined: Jun 2011
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
From: Forest Lake,
MN
Nitro engine needed! Please help
I just throw my rod in my Picco .80. I'm not sure there will be any parts for this. It's a mono/inboard. If any one could give me some similiar recommendations and/or where to find one that would be great.
Thanks
Blake
</p>
09-10-2011 | 10:15 AM
#2
Senior Member
Joined: Nov 2008
Posts: 1,444
Likes: 0
Received 0 Likes
on
0 Posts
From: hamilton,
ON, CANADA
RE: Nitro engine needed! Please help
i have a picco .80 its in great condition has about 1/2 -3/4 of a gallon of fuel through it compression is verry good bearrings are smooth
09-10-2011 | 10:55 AM
#3
RE: Nitro engine needed! Please help
Measure the rod ... maybe a OPS or CMB rod will fit.
Send the remains to Brad Christy .. he can make you a titanium-rod.
If it's a 7mm/6mm/<41mm> rod ... you're lucky ... I have one .. and a OPS will fit.
Send the remains to Brad Christy .. he can make you a titanium-rod.
If it's a 7mm/6mm/<41mm> rod ... you're lucky ... I have one .. and a OPS will fit.
