STS D28M
07-04-2007, 02:15 PM
#1
Senior Member
Thread Starter
Join Date: Nov 2005
Location: NanjingJiangsu, CHINA
Posts: 852
Likes: 0
Received 0 Likes
on
0 Posts
STS D28M
hey
I just realized that this engine has a ST shaft, like no threads than a little threads then none agian. should i just cut the shaft to put my coupler on? thnaks
Dan
I just realized that this engine has a ST shaft, like no threads than a little threads then none agian. should i just cut the shaft to put my coupler on? thnaks
Dan
07-04-2007, 10:58 PM
#3
RE: STS D28M
An SG shaft?
It's a holiday over here in the US so peolpe are out doing otherv things besides hanging around there computers, like getting drunk and blowing off fingers with fireworks!
Yes, you'll have to cut off the end of the shaft to get a flex cable collet on there. Now the fun begins in finding a flywheel thin anough to put on there and have enough threads so that things don't come apart at speed.
It's a holiday over here in the US so peolpe are out doing otherv things besides hanging around there computers, like getting drunk and blowing off fingers with fireworks!
Yes, you'll have to cut off the end of the shaft to get a flex cable collet on there. Now the fun begins in finding a flywheel thin anough to put on there and have enough threads so that things don't come apart at speed.
