Mean Green Hot Shot 2 w 7.5
#1
Senior Member
Thread Starter
Join Date: Oct 2006
Location: Wilmington,
NC
Posts: 271
Likes: 0
Received 0 Likes
on
0 Posts
Mean Green Hot Shot 2 w 7.5
When I first recieved this boat it was some kind of ugly. It was partially built by a troll w/ only thumbs and needed some serious sanding time and tlc . I finished her a few months back and now its hotter than 40 hells outside it time to finish setting her up
#2
Member
Join Date: Jun 2010
Location: NW,
WI
Posts: 86
Likes: 0
Received 0 Likes
on
0 Posts
RE: Mean Green Hot Shot 2 w 7.5
My brother has the same boat and motor. His motor is piped, however. Runs really well. Can handle a little wave action too. Gotta ask, are those 4 magnets that hold thecowl down?
#3
Senior Member
Join Date: Nov 2008
Location: hamilton,
ON, CANADA
Posts: 1,444
Likes: 0
Received 0 Likes
on
0 Posts
RE: Mean Green Hot Shot 2 w 7.5
working on a similar project for giggles lapcat III with a K&B .67 O/B engine was in like new condition but the hull was a basket case getting ready for paint
#4
Senior Member
Thread Starter
Join Date: Oct 2006
Location: Wilmington,
NC
Posts: 271
Likes: 0
Received 0 Likes
on
0 Posts
RE: Mean Green Hot Shot 2 w 7.5
the magnets are rare earth magnets from harbour frieght . At first I just had the rear two but added the front two for a really good SNAP shut. I drilled out some square dowel I had and then epoxied them in I made a sharpie mark on opposing magnet sides to get polarity right
#5
Senior Member
Thread Starter
Join Date: Oct 2006
Location: Wilmington,
NC
Posts: 271
Likes: 0
Received 0 Likes
on
0 Posts
RE: Mean Green Hot Shot 2 w 7.5
Heres my other one . It also has a 7.5 . Ive had it running for about a year and love it. Thier an older design but ive been very happy w speed and performance.
#6
Member
Join Date: Jun 2010
Location: NW,
WI
Posts: 86
Likes: 0
Received 0 Likes
on
0 Posts
RE: Mean Green Hot Shot 2 w 7.5
Very nice. It's a good running hull even for Dumas(actually, that's all we run except for a VS1)..... I showed my brother your magnet setup, we both thought it was a great idea.... Never would have thought of it....