flywheel
#1
Junior Member
Thread Starter
Join Date: Oct 2009
Location: amherst ns, NS, CANADA
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
flywheel
hello all am wanting a flywheel for an eyna .09 tv iv or specs for one that i can have machined wantint to finish my short stuff fiberglass boat thanks in adavancs
#2
Join Date: Apr 2006
Location: Augusta,
KS
Posts: 1,983
Likes: 0
Received 0 Likes
on
0 Posts
RE: flywheel
Not sure but IF you have some measurements Amax (adam) here on RCU might be able to make you one, I believe he has the material and I know hes made some flywheels for other motors, never hurts to ask..
#3
Senior Member
Join Date: Dec 2009
Location: winter haven, FL
Posts: 234
Likes: 0
Received 0 Likes
on
0 Posts
RE: flywheel
i have a extra flywheel that is for small motors i bought three off ebay and one fit my os.20
the one that is the smallest is brass made by sterling 5/8 thick, 1 5/8 across, hole looks like 3/8
10.00 shipped.
the one that is the smallest is brass made by sterling 5/8 thick, 1 5/8 across, hole looks like 3/8
10.00 shipped.
#5
Junior Member
Thread Starter
Join Date: Oct 2009
Location: amherst ns, NS, CANADA
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
RE: flywheel
hello fellow boaters
wish to thank all of for your imput i have tried octura they have nothing i will keep looking something may turn up
wish to thank all of for your imput i have tried octura they have nothing i will keep looking something may turn up
#6
RE: flywheel
Your target weight for a .09 is 1.5oz. I say that as a .051 Tee Dee needs a 1oz flywheel Dumas makes flywheels. There 1/2A fly wheel wont work unless you have throttle and can keep the rev's down till your motor is loaded on the water. The make other sizes you want there next size up. If its heavy you can take off some material.