what servos
 

im running a miss bud 1/12 scale with a Go.18 engine & aquacraft strut and rudder ..... and was wondering if i should go with micro servos and should i use metal geared instead of standard?

i know about the hitech what about the bluebird?

RE: what servos
 

go metal gears and make sure there high tork.. you need a hight tork servo on the rudder/steering..;)

RE: what servos
 

thanks so mg on both? how much tork should i look for? i was looking at the bluebird for the price.

RE: what servos
 

40 to 50oz torque for the throttle will be sufficient (micro or standard).

80 to 90oz for the rudder (standard) (metal gear would be nice but for that size boat probably not a requirement)on a 1/12 scale is fine, the Miss Vegas uses 44oz torque on both throttle and rudder.

Dan.

RE: what servos
 

ok thanks for the info, looking around on tower i dont see any micro with that much tork , and certain ones i should look for ? i mainly want micro due to size of cutom radio box goin in.


how about these ?

http://www3.towerhobbies.com/cgi-bin...&I=LXN667&P=ML

RE: what servos
 

stock servos are 42oz of tork.. I have a traxxas 2055 high tork that is 85oz of tork on my Oberto;). there higher tork one that go to 125oz..85 oz is planty of for steering for rudder. running that 85oz tork servo make my steering fast!!:D better responce too.:D

RE: what servos
 

looking for micro servos . ....

RE: what servos
 

try to find a mini/micro servo that has the highest tork in them.. like Dan said steering and throtle form stock are running 42oz on both. But steering you need a higher tork servo aspeicaly running at faster speeds the waterand boat puts a load on the rudder more..

RE: what servos
 

how about these?

http://www3.towerhobbies.com/cgi-bin...?&I=LXLN95&P=7


http://www3.towerhobbies.com/cgi-bin...?&I=LXN667&P=7

RE: what servos
 

Tower Hobbies,

Futaba S3102 Micro: 51oz @ 4.8v or 64oz @ 6.0v
http://www3.towerhobbies.com/cgi-bin...?&I=LXH291&P=7

Hitec HS-82MG Micro: 38oz @ 4.8v or 43oz @ 6.0v
http://www3.towerhobbies.com/cgi-bin...?&I=LXTRE2&P=M

Dan.

RE: what servos
 

thanks guys for the help will the ones in the post above dans work im leaning towards getting 2 of the hobbico ones if there enought for the boat

RE: what servos
 

Russ that 66.7 oz tork sevo you listed,I would go with that..for steering..;)

RE: what servos
 

ok will do, now if i can only get a 20.00 off a 50.00 order from tower ill be good to go.