dude7422

don you know its ok to cut wires down so you dont have like 5feet of wire on heli

J-MICHAEL

Just be advised it will void the warranty on the component if done......

don_87

You must me referring to the wires on the rx, I need them that long to be able to remove the rx easily for rebinding when necessary. Where the bind plug goes on the 7000 rx is up against the motor in my application.

audiov005

heres my battle scared exi

copterx head and tail
hxt 900
gy-400 gyro with gws hpx servo
supersimple 30a esc
turnigy e500 motor
hobywing ubec
since i using a 7cap, installed a esky rx
zippy 2200

all this minus tx for about 150$

baurwin

cx450se v2

hitec hs65 mg servos x 3
futaba s9257 tail
futaba gy401
scorpion -8 motor
castle 45 esc
align skids
align airbrushed canopy
ar6100 rx

baurwin

here is the maiden hover, i was a little scared but she flys pretty good. almost lost it about half way through, i was doing a piro and my thumb started slipping off the right stick. i was like holy crap. once i got it on the ground it was trying to tip over, i thought the blades were gonna scrape for sure. i hit throttle hold and full negative pitch and it pushed it back down on both skids thankfully. needless to say, i dont think i did any more piro's the rest of the day. spent the next 3 packs just trying to get aquainted with o girl.


[link]http://www.youtube.com/watch?v=FIoWRVtO8uM[/link]

NM_Mark

My Feedback: (8)

Here's my HK-450 with an Align canopy, my SE V1 head, and V1 motor and electronics. It's sitting with my E550 that I just finished putting together.

Mark

L0stS0ul

Here's the Flasher450 SE available for $135 plus free shipping from SNHobbies

I did a complete build thread for it. I can't tell the difference between this and a trex se v2
http://www.rcuniverse.com/forum/m_8661366/tm.htm

Maiden Flight video:

[youtube]http://www.youtube.com/watch?v=jnF7PZ1k8Bc[/youtube]

dude7422

lost you take the cake for spreading around the web lol

dude7422

anyone figure out a way of getting the silk screen print off tail boom
thinking of polishing frame plates

mksubaru

here is my clone, its a HKH 450, it cost me about 70€ shipping included, i´m steel bilding it up

eaterofdog

My Feedback: (1)

Scrape it with a piece of hard plastic. That will remove the screen without harming the ano.

I like the gold clones. China finally figured out how to anodize in a color besides blue, LOL.

mksubaru

LOL they also have green already

dude7422

mks i wonder if china will ever do hard anodize the army green