CMPRO super chipmunk 120
01-27-2011 | 05:33 PM
#1
Thread Starter
Member
Joined: Jul 2008
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
From: San Pedro, DOMINICAN REPUBLIC
CMPRO super chipmunk 120
Hi guys, im just starting to build my new super chipmunk with DLE 20 gasser any tips and recomendations for reinforcements will be appreciated. I heard something about the landing gear blocks, so please if you can give some recomendation. Im planning to use FUTABA S3305 on elevator and ruder and FUTABA S3010 in all other places.
Ruder pull and pull system, Dubro sclae tail wheel with pull and pull system as well.
4/40 rods for elevator and alerons.
Dubro 91-UP HD Hardware.
Duralite A123 230mAh batteries on ignicion and electronics.
Im open to suggestions
Regards
Alejandro.
Ruder pull and pull system, Dubro sclae tail wheel with pull and pull system as well.
4/40 rods for elevator and alerons.
Dubro 91-UP HD Hardware.
Duralite A123 230mAh batteries on ignicion and electronics.
Im open to suggestions
Regards
Alejandro.
01-29-2011 | 04:40 AM
#2
RE: CMPRO super chipmunk 120
Great airplane to model!
I offer graphics for that model. Have for many years in any size. This one is a customer's model, at 25%. He did a great job!
I offer graphics for that model. Have for many years in any size. This one is a customer's model, at 25%. He did a great job!
02-14-2011 | 03:39 PM
#3
Senior Member
Joined: Oct 2005
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
From: Lloydminster,
AB, CANADA
RE: CMPRO super chipmunk 120
