Tri-Color Paint lines
01-20-2005 | 10:00 AM
#1
Tri-Color Paint lines
I am trying to paint an F6F-3 Hellcat with the tri-color scheme. I am having a heck of a time getting the shaded line to work between colors (flat white on bottom, non-specular intermediate blue in middle and non-specular sea blue on top). I seem to get a lot of overspray on the lighter color when shooting the other color. I have tried an airbursh and shot just the line, then reshot the rest with a touch up gun (binks 400), but the effect just isnt right. Any suggestions? Also.... I have had really crappy results with latex. It doesnt seem to smooth out completely. What am I doing wrong? I have tried upping the spray pressure, lowering the feed volume, but not reallly a good finish results. I really miss the Chevron and Nelson paints. If anyone knows where I can find some in the above colors.... Please let me know!!
Thanks
Thanks
01-20-2005 | 03:51 PM
#2
My Feedback: (1)
RE: Tri-Color Paint lines
I've done a few planes in the tricolor scheme using latex. I spray the lighter colors first but usually some of the darker color does get on the lighter ones. I go back over the lighter colors with the airbrush and touch them up where the darker overspray got on.
With latexes, you want lower pressure and higher volume. If you use too much air it makes it dry too fast. You also have to play with the thinning to get it to flow right. Also, I keep a small bottle of water with some Mr. Clean in it, and a small stiff brush, to keep the gun and/or airbrush tip clean.
Jim
With latexes, you want lower pressure and higher volume. If you use too much air it makes it dry too fast. You also have to play with the thinning to get it to flow right. Also, I keep a small bottle of water with some Mr. Clean in it, and a small stiff brush, to keep the gun and/or airbrush tip clean.
Jim
02-16-2005 | 02:36 AM
#3
My Feedback: (5)
Joined: Nov 2004
Posts: 272
Likes: 0
Received 0 Likes
on
0 Posts
From: Portland,
OR
RE: Tri-Color Paint lines
Look Here ---> www.warbirdcolors.com
a water-based, polyurathane, fuel proof paint. It can be sprayed, brushed, air-brushed. Sticks to anything, dries HARD, and the colors are accurate.
a water-based, polyurathane, fuel proof paint. It can be sprayed, brushed, air-brushed. Sticks to anything, dries HARD, and the colors are accurate.
02-17-2005 | 09:48 AM
#4
RE: Tri-Color Paint lines
Great... this is a good thing. 
However, I dont see flat white (FS 37875) or a flat clear for decal sealing. [
] Is this your company ( I noticed your nickname is the same as the site you sent me to)? and is the "crosslinker" Polyurethane accelerator?
However, I dont see flat white (FS 37875) or a flat clear for decal sealing. [] Is this your company ( I noticed your nickname is the same as the site you sent me to)? and is the "crosslinker" Polyurethane accelerator?
02-17-2005 | 10:56 AM
#5
My Feedback: (24)
RE: Tri-Color Paint lines
ORIGINAL: corsaircrazy
I seem to get a lot of overspray on the lighter color when shooting the other color. I have tried an airbursh and shot just the line, then reshot the rest with a touch up gun (binks 400), but the effect just isnt right. Any suggestions?
I seem to get a lot of overspray on the lighter color when shooting the other color. I have tried an airbursh and shot just the line, then reshot the rest with a touch up gun (binks 400), but the effect just isnt right. Any suggestions?
02-17-2005 | 10:59 AM
#6
My Feedback: (24)
RE: Tri-Color Paint lines
ORIGINAL: warbirdcolors
Look Here ---> www.warbirdcolors.com
a water-based, polyurathane, fuel proof paint. It can be sprayed, brushed, air-brushed. Sticks to anything, dries HARD, and the colors are accurate.
Look Here ---> www.warbirdcolors.com
a water-based, polyurathane, fuel proof paint. It can be sprayed, brushed, air-brushed. Sticks to anything, dries HARD, and the colors are accurate.
02-22-2005 | 03:56 AM
#7
My Feedback: (5)
Joined: Nov 2004
Posts: 272
Likes: 0
Received 0 Likes
on
0 Posts
From: Portland,
OR
RE: Tri-Color Paint lines
Warbirdcolors can match any Federal Standard color upon request. Custom orders via [email protected]. The minimum size for a custom color is 1 quart, anything smaller gets hard to get right. There is a satin clear, not dead flat. (looks like skim milk in the can, but dries to a satin-clear) The crosslinker provides the fuel-proof properties, but also acts as a slow catalyst.
02-22-2005 | 01:34 PM
#8
Senior Member
My Feedback: (1)
RE: Tri-Color Paint lines
ORIGINAL: corsaircrazy
I am trying to paint an F6F-3 Hellcat with the tri-color scheme. I am having a heck of a time getting the shaded line to work between colors (flat white on bottom, non-specular intermediate blue in middle and non-specular sea blue on top). I seem to get a lot of overspray on the lighter color when shooting the other color. I have tried an airbursh and shot just the line, then reshot the rest with a touch up gun (binks 400), but the effect just isnt right. Any suggestions? Also.... I have had really crappy results with latex. It doesnt seem to smooth out completely. What am I doing wrong? I have tried upping the spray pressure, lowering the feed volume, but not reallly a good finish results. I really miss the Chevron and Nelson paints. If anyone knows where I can find some in the above colors.... Please let me know!!
Thanks
I am trying to paint an F6F-3 Hellcat with the tri-color scheme. I am having a heck of a time getting the shaded line to work between colors (flat white on bottom, non-specular intermediate blue in middle and non-specular sea blue on top). I seem to get a lot of overspray on the lighter color when shooting the other color. I have tried an airbursh and shot just the line, then reshot the rest with a touch up gun (binks 400), but the effect just isnt right. Any suggestions? Also.... I have had really crappy results with latex. It doesnt seem to smooth out completely. What am I doing wrong? I have tried upping the spray pressure, lowering the feed volume, but not reallly a good finish results. I really miss the Chevron and Nelson paints. If anyone knows where I can find some in the above colors.... Please let me know!!
Thanks
If you can bring a sample of the color you want to a paint store they can color match it for about $10 per quart.
