I anm converting the Seagull models 3d bling to electric. This plane requires multiple servos on each surface. I have 4 smart fly equalizers, one for each servo group. What is the best, easiest, correct way for syncing the servos with this device. I have spent days trying to set up the left wing aileron servos. I have a 9chp futaba, I think that is the model, anyway, does it have the sync capability built in?

I thought that model used one servo per surface?
ailerons in 1 and 6, use flaperon
elevators in 2 and 8, use ailevator
throttle in 3
rudder in 4

What about centering and end point adjustments. There are a total of 8 servos. I going electric. 4 for ailerons 2 for elevator and 2 for rudder. I just want to set up the servos properly.