How to Secure Nyrod in Firewall?
06-04-2007 | 05:34 PM
#1
Thread Starter
My Feedback: (1)
How to Secure Nyrod in Firewall?
For those of you who use a nyrod for throttle, how do you keep the outer sleeve from slipping in the firewall? I find that over time it moves with the inner portion and works it way out of the firewall hole, even if I epoxy it.
06-04-2007 | 06:03 PM
#2
My Feedback: (21)
RE: How to Secure Nyrod in Firewall?
RTV, silicon sealer sticks to the plastic outer housing of the ny-rod, and will secure
it to the firewall. Next time, use a smaller hole, so the ny-rod is tight to begin with.
The sealer will help hold it, and will prevent any fuel or oil from getting into the plane
as well.
FBD.
it to the firewall. Next time, use a smaller hole, so the ny-rod is tight to begin with.
The sealer will help hold it, and will prevent any fuel or oil from getting into the plane
as well.
FBD.
06-30-2007 | 11:07 PM
#6
Senior Member
Joined: May 2005
Posts: 371
Likes: 0
Received 0 Likes
on
0 Posts
From: Houston, TX
RE: How to Secure Nyrod in Firewall?
I use Sullivan Gold n Rods a lot since I build mostly 40 size plans. My usual is the sand (very important) and CA method but I have used a hot melt glue gun to hold it.
07-01-2007 | 12:00 AM
#7
Senior Member
Joined: Sep 2003
Posts: 1,180
Likes: 0
Received 0 Likes
on
0 Posts
From: Fresno, CA
RE: How to Secure Nyrod in Firewall?
ORIGINAL: dbacque
Sand it first, then epoxy or CA will stick to it fine.
Dave
Sand it first, then epoxy or CA will stick to it fine.
Dave
Fit needs to be tight, so if you have to make the hole larger to allow a straight run for the throttle cable, make a doubler of 1/8 thick ply with a tight hole in it - CA to firewall over the larger hole. The doubler method also works well to stabilize a long run of nyrod..
Cheers!
Jim
