1/2A twin control line engine mounting
#1
Senior Member
Thread Starter
Join Date: Nov 2004
Location: Arlington,
VA
Posts: 105
Likes: 0
Received 0 Likes
on
0 Posts
1/2A twin control line engine mounting
Hi,
I'm building a 1/2A twin A-26 for control line. I'm wondering how to mount the enguines. All control line twins I've seen have the cylinders mounted facing the outside of the circle. I was wondering if I could mount the inner engine with the cylinder facing to the left instead of to the right. WIll this not run properly for a control line situation?
thasnks
Rob
I'm building a 1/2A twin A-26 for control line. I'm wondering how to mount the enguines. All control line twins I've seen have the cylinders mounted facing the outside of the circle. I was wondering if I could mount the inner engine with the cylinder facing to the left instead of to the right. WIll this not run properly for a control line situation?
thasnks
Rob
#2
Senior Member
My Feedback: (3)
Join Date: Nov 2002
Location: Mary Esther, Florida, FL
Posts: 20,205
Likes: 0
Received 14 Likes
on
13 Posts
RE: 1/2A twin control line engine mounting
Bog:
This is almost the same post you put in Control Line, making it effectively a double post.
I'm not going to delete it as this is a good place to ask the question also, but I am going to lock it and not allow replies.
If any reader/user has a comment or suggestion please click [link=http://www.rcuniverse.com/forum/Twin_engine_mounting/m_2418095/tm.htm]here[/link] to go to the original thread.
Thanks.
Bill.
This is almost the same post you put in Control Line, making it effectively a double post.
I'm not going to delete it as this is a good place to ask the question also, but I am going to lock it and not allow replies.
If any reader/user has a comment or suggestion please click [link=http://www.rcuniverse.com/forum/Twin_engine_mounting/m_2418095/tm.htm]here[/link] to go to the original thread.
Thanks.
Bill.