RCU Forums - Edge 540

RCU Forums (https://www.rcuniverse.com/forum/)

- WildHare R/C Support (https://www.rcuniverse.com/forum/wildhare-r-c-support-355/)

- - Edge 540 (https://www.rcuniverse.com/forum/wildhare-r-c-support-355/4135960-edge-540-a.html)

krohde

04-07-2006 10:31 AM

Edge 540

I have a question about the cowl on my 28% edge? Do I need to re-enforce the screw holes to keep them from cracking.
Some of my other cowls have cracked and I was wondering if this is a issue with my Wild Hare Edge...

ben beyer

04-07-2006 11:24 AM

RE: Edge 540

I usually go to the hardware store and pick up some grommets to put in the holes. I just drill them out and push the grommet in. It takes a little work, but I don't have any problems from the vibration of the engine.

bluemagic98

04-07-2006 03:00 PM

RE: Edge 540

I found a small slice of fuel tubing under the washer and mash it workes for me I have 70 hours on the edge and no problems

shogunmst

04-07-2006 08:36 PM

RE: Edge 540

No problems, I just use small rubber washers under the metal washers and I never had any problems.....

Rockyaged

04-09-2006 09:24 PM

RE: Edge 540

You can also use bonded washers... rubber material bonded to
the washer. Also acts as an anti-vibration lock.

Gerald

Ken Bryant

04-09-2006 09:57 PM

RE: Edge 540

I use the Bonded washers. You can get them from Fastnal if you have one near by.

mstroh3961

04-10-2006 02:15 AM

RE: Edge 540

Quote:

ORIGINAL: Ken Bryant

I use the Bonded washers. You can get them from Fastnal if you have one near by.

Home depot caries these as well....I use them too.

All times are GMT -8. The time now is 05:56 PM.