RCU Forums - EXI 250

RCU Forums (https://www.rcuniverse.com/forum/)

- XHeli.com Support Forum (https://www.rcuniverse.com/forum/xheli-com-support-forum-496/)

- - EXI 250 (https://www.rcuniverse.com/forum/xheli-com-support-forum-496/9784380-exi-250-a.html)

Andy or AnyoneCan you give me the run down on the EXI 250 (things needed to finish)A list other then the radio systemServos size or number part number (standard and digital)Tail Servo (digital)Gyro MotorAnything else I may need.Thanks RCREDHOTS

now the exi 250 uses the same electronics as the trex 250 so you can see what the pro ppl have on their trex 250.

you'll need micro servo 3 for the cyclic and one for the tail. you can use our gy48V and that will do it. for motor you can get them here: http://www.xheli.com/200sibrmo.html

you'll need 11.1v 800mah 30C lipo for the heli.

:)

Andy

Do I have a 2nd or 3rdchoice on the motor? one place I found said a 34 KV and one more was higher.
And what size is the drive pinion (is it 2 mm)
It would be better if the page listed a list of items / parts to finish! in a little more detail!
If you want me to buy from Xheli toss me a bone!
How about the D213F servos?

Quote:

ORIGINAL: yadac123

now the exi 250 uses the same electronics as the trex 250 so you can see what the pro ppl have on their trex 250.

you'll need micro servo 3 for the cyclic and one for the tail. you can use our gy48V and that will do it. for motor you can get them here: http://www.xheli.com/200sibrmo.html

you'll need 11.1v 800mah 30C lipo for the heli.

:)

Andy

ok motor: http://www.hobbypartz.com/250class-5150kv.html
servos: http://www.hobbypartz.com/9gexidimeges.html
gyro: http://www.hobbypartz.com/60p-dy-1017.html
ESC: http://www.hobbypartz.com/topro40aelbr.html

the shaft size on this motor is 2.3 and the pinon gear that came with the kit will work on this motor.

Thanks
Andy