Community
Search
Notices
YS Engines Support Direct support from YS Performance Engines by Dave Shadel

YS110

Thread Tools
 
Search this Thread
 
Old 11-04-2005 | 06:28 PM
  #1  
Thread Starter
Senior Member
 
Joined: Oct 2005
Posts: 110
Likes: 0
Received 0 Likes on 0 Posts
From: Pampatarpampatar, VENEZUELA
Default YS110

Dear Dave.

My YS 110 stops running well at high speed after been running good for months. It is not getting full rpms after some minutes on the air, it starts to run pretty irregular at high rpms. After re-fueling, it gets worst Should I re-adjust the regulator (little in)?. I saw a bit of oil after flying at the sealing of the piston /cranckcase , but not sure if it was the same before. Dont want to open and change the gasket before you tell me what you think. Thanks.
Old 11-05-2005 | 01:23 AM
  #2  
Senior Member
 
Joined: Apr 2002
Posts: 5,385
Likes: 0
Received 1 Like on 1 Post
From: Gardnerville, NV
Default RE: YS110

Check all the bolts in the engine first. Reset the valves to .003"

Go through the running instructions at www.ysperformance.com

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are On



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.