Disassembling YS91FZ
03-17-2003 | 04:59 AM
#1
Thread Starter
Joined: Oct 2002
Posts: 307
Likes: 0
Received 0 Likes
on
0 Posts
From: Houston, TX
Disassembling YS91FZ
Hi Dave,
I'd like to disassemble my YS91FZ to just inspect and clean it (it's into its first 5 months of running now) but as it's my first four stroke I'm a little apprehensive about what I should do/be aware of. Is there anything I need to be careful to note so I don't reinstall backwards, or is there a recommended procedure in taking the engine apart? Thanks for your advice.
Cheers,
Ken
I'd like to disassemble my YS91FZ to just inspect and clean it (it's into its first 5 months of running now) but as it's my first four stroke I'm a little apprehensive about what I should do/be aware of. Is there anything I need to be careful to note so I don't reinstall backwards, or is there a recommended procedure in taking the engine apart? Thanks for your advice.
Cheers,
Ken
03-17-2003 | 03:30 PM
#2
Senior Member
Disassembling YS91FZ
If your engine is running OK, DON'T take it apart.
If you do, have all the replacement seals and gasket sets at hand so they can be changed.
Last of all, if you don't have the experience necessary for this job, let someone who knows YS engines do it for you.
Good Flying,
Dave
If you do, have all the replacement seals and gasket sets at hand so they can be changed.
Last of all, if you don't have the experience necessary for this job, let someone who knows YS engines do it for you.
Good Flying,
Dave
