bokings

The EDF Cessna 185 cost few from China, we could ship everyone.

beaver180

My Feedback: (10)

Yo there Rossco...

Hey I like what you've done with the tail wheel on the Cessna, can you post a picture of it please? Have you cut off the original tail wheel and soldered on a metal control horn for the springs?

Cheers, Paul

haisanjafri

Dear Planker07,

I inted to buy this model. Should OS 160FXwill be fine OR should go for DL30cc gasser? Iintend to make it a banner tower. Please comment!

Regards,

Sunny.

haisanjafri

Dear BIGNUTS181,

I inted to buy this model. Should OS 160FXwill be fine OR should go for DL30cc gasser? Iintend to make it a banner tower. Please comment!

Regards,

Sunny.

beaver180

My Feedback: (10)

Hey there Sunny.... No replies huh? well I'll tell you I have a Saito 180 FS engine in mine and it goes superb! If I did not have the Saito I would 100% go for the DLE30 the newer rear carby one.

The OS would have the grunt and go well but it will not sound good and will use much more fuell too. Just my opinion anyway :-)

Cheers, Paul

haisanjafri

Thanks for the response paul.

Regards, Sunny.

haisanjafri

Dear Bignuts181,

I saw you are towing a glider with your Cessna, can you please guide what mechanism are you using? Because Isaw cord coming from the wing whereas Iused to tow the banner below the fuselage

Regards, Sunny.

vasek

My Feedback: (4)

Can someone who got the floats measure their length?

I would use the floats on a project, but can't find their dimensions online.

Thanks,v.

estuardopassa

HELLO
THOSE WHO HAVE USE 50CC IN THE ESM CESSNA 185
I APPRECIATE IT IF YOU CANT GIVE ME HOW MUCH RIGHT THURST AND DOWN THURST YOU HAVE

THANKS