Servos for Skymaster Large Hawk?
#1
Thread Starter
Servos for Skymaster Large Hawk?
Hi guys
What servos are you using for the Skymaster large Hawk?
For elevator and flaps I am planning to use JR 8711, but I am wondering if using the same for ailerons and rudder would be overkill. Would JR 8411 work ok?
Regards
Eduardo
What servos are you using for the Skymaster large Hawk?
For elevator and flaps I am planning to use JR 8711, but I am wondering if using the same for ailerons and rudder would be overkill. Would JR 8411 work ok?
Regards
Eduardo
#2
My Feedback: (95)
Join Date: Aug 2002
Location: Mason, OH
Posts: 982
Likes: 0
Received 0 Likes
on
0 Posts
RE: Servos for Skymaster Large Hawk?
I just finished mine and I used 8711 all the way around. I think it is more than need on the aileron and elevator but the 8411 are not that much cheaper than the 8711's So I jused 8711's. Some trimming is needed to fit the 8711 in the mounts, but its not a big deal.
#5
RE: Servos for Skymaster Large Hawk?
Hi
I am a Futaba guy and used 9156 for elevator and flaps, BLS451 for ailerons and BLS153 for Rudder.
IMy kit as 2 years old and as not yet been maiden. I have a P160 but the fuel tank is very small-less than 3 liters.
Do you have 1 fuel tank? Did you measured it?
Thanks
Nuno
I am a Futaba guy and used 9156 for elevator and flaps, BLS451 for ailerons and BLS153 for Rudder.
IMy kit as 2 years old and as not yet been maiden. I have a P160 but the fuel tank is very small-less than 3 liters.
Do you have 1 fuel tank? Did you measured it?
Thanks
Nuno
#8
Thread Starter
RE: Servos for Skymaster Large Hawk?
I already ordered 8711 all arround.
I,ll use a powerbox, that regulated to 6 volts, so no need to go to Hv.
Regards
Eduardo
I,ll use a powerbox, that regulated to 6 volts, so no need to go to Hv.
Regards
Eduardo