RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 9
1
2
3
Last »
Search: Posts Made By: WrathSkeller
Showing results 1 to 25 of 204
Search took 0.96 seconds.
Forum: RC Nitro Stadium Trucks
08-13-2006, 08:34 PM
Replies: 1,422
Views: 116,050
Posted By WrathSkeller

RE: Stadium Truck Gallery v.2

lol you need to clean that thing :D
Forum: RC Nitro Stadium Trucks
08-13-2006, 08:26 PM
Replies: 65
Views: 2,126
Posted By WrathSkeller

RE: Rate my vid

you cant really see the truck that much but its not too bad, ive seen a lot worse
Forum: RC Nitro Stadium Trucks
08-09-2006, 07:16 PM
Replies: 2,243
Views: 281,148
Posted By WrathSkeller

RE: Official XTM X-Cellerator thread!!

cool thanks for the quick reply!! :D Hey has anyone here gone to their track and race their x-c??
Forum: RC Nitro Stadium Trucks
08-09-2006, 06:33 PM
Replies: 2,243
Views: 281,148
Posted By WrathSkeller

RE: Official XTM X-Cellerator thread!!

I'm not sure if the x-c's come with the agressor radio still...even though it is a decent radio for a ready to run truck you should still want to upgrade which brings me to this question: what radio...
Forum: RC Car General Discussions
08-07-2006, 11:09 PM
Replies: 42
Views: 2,619
Posted By WrathSkeller

RE: To all teens

yeah a job is biggest thing when you get old enough (15)you should really get a job or do what dustin7837 said i do that too and it pays well i also umpire baseball games b/c other than r/c baseball...
Forum: RC Nitro Stadium Trucks
08-05-2006, 10:36 PM
Replies: 2,243
Views: 281,148
Posted By WrathSkeller

RE: Official XTM X-Cellerator thread!!

well i haven't seen anyone post here in a while, but anyway i just dropped an O.S. .18 CV-R in my x-c and after breaking it in and tuning it properly this thing hauls ***** the stock xtm .18 was quick...
Forum: RC Nitro Stadium Trucks
08-04-2006, 09:34 PM
Replies: 2,243
Views: 281,148
Posted By WrathSkeller

RE: Official XTM X-Cellerator thread!!

i agree with doyab on this one x-cell all the way [8D]
Forum: RC Nitro Stadium Trucks
08-04-2006, 09:26 PM
Replies: 11
Views: 638
Posted By WrathSkeller

RE: my little mechanics have been at it again help

put your trim in the middle (with the car off, electronics on) and adjust your idle set screw this should help
Forum: RC Nitro Stadium Trucks
08-04-2006, 09:19 PM
Replies: 1
Views: 474
Posted By WrathSkeller

RE: help with throttle arm please!!!

this is perfect as im tuning my new engine right now, first off how much of an adjustment are you making? Adjustments should be made in very small increments at a time like 1/16th or an eighth of a...
Forum: RC Nitro Stadium Trucks
08-02-2006, 11:06 AM
Replies: 9
Views: 690
Posted By WrathSkeller

RE: How do you Removed the tire from the rim

haha good one, damn ICrashThings, i haven't seen you on here in awhile
Forum: RC Nitro Stadium Trucks
08-01-2006, 11:15 PM
Replies: 9
Views: 690
Posted By WrathSkeller

RE: How do you Removed the tire from the rim

if you dont mind waiting u can also soak them in a bucket of acetone over night, you can do it right before u go to bed and they will be ready righ twhen u wake up. It probably doesn't take that long...
Forum: RC Nitro Stadium Trucks
08-01-2006, 10:25 PM
Replies: 3
Views: 407
Posted By WrathSkeller

RE: Brake Closes Carb Please Help!!!

thanks but i haven't had any problems yet, i haven't even broken in the engine. i want to fix this is so it doesnt cause problems but thanks for the replies any more suggestions??
Forum: RC Nitro Stadium Trucks
08-01-2006, 06:14 PM
Replies: 3
Views: 407
Posted By WrathSkeller

Brake Closes Carb Please Help!!!

ok i just installed a new O.S. .18 CV-R into my x-cell. I started to set up my linkages and everytime i press the brake on the transmitter the carb comes close to closing the carb opening all the...
Forum: RC Nitro Stadium Trucks
07-26-2006, 02:00 PM
Replies: 2,243
Views: 281,148
Posted By WrathSkeller

RE: Official XTM X-Cellerator thread!!

annie, correct if i'm wrong (because i'm no where near being a rc veteran) but doesn't a pipe affect the way the flow of exhaust exits the engine? If you have a pipe with more flow the hp or power of...
Forum: RC Nitro Stadium Trucks
07-25-2006, 08:10 PM
Replies: 2,243
Views: 281,148
Posted By WrathSkeller

RE: Official XTM X-Cellerator thread!!

i will do that but i wanted a better pipe for more performance anyway
Forum: RC Nitro Stadium Trucks
07-25-2006, 03:12 PM
Replies: 2,243
Views: 281,148
Posted By WrathSkeller

RE: Official XTM X-Cellerator thread!!

o.k. i'm going to get an O.S. .18 CV-R but i noticed it is a side exhaust engine (or atleast i think) so can someone give me a link to a suitable manifold to go on it and a good tuned pipe?
Forum: Car Nitro & Gas Engines
07-24-2006, 10:04 PM
Replies: 0
Views: 659
Posted By WrathSkeller

LRP's .18 VTEC

I have a x-cellerator and want to replace the stock .18 XTM engine with LRP's .18 VTEC i think it would be a direct drop in but the VTEC is a side exhaust, does anyone know if i can buy a exhaust...
Forum: RC Nitro Stadium Trucks
07-24-2006, 09:12 PM
Replies: 2,243
Views: 281,148
Posted By WrathSkeller

RE: Official XTM X-Cellerator thread!!

hey guys thanks for the replies now what about a good replacement engine, i do a lot of bashing and street racing (street meaning unofficial) im looking to spend from 100 to 130, any size small block...
Forum: RC Nitro Stadium Trucks
07-24-2006, 08:27 PM
Replies: 2,243
Views: 281,148
Posted By WrathSkeller

RE: Official XTM X-Cellerator thread!!

where and how much can i get one for??
Forum: RC Nitro Stadium Trucks
07-24-2006, 08:19 PM
Replies: 2,243
Views: 281,148
Posted By WrathSkeller

RE: Official XTM X-Cellerator thread!!

Another question: Does the stock XTM motor have a reg. shaft or a pilot shaft? I think its reg. but im not sure
Forum: RC Nitro Stadium Trucks
07-24-2006, 08:18 PM
Replies: 2,243
Views: 281,148
Posted By WrathSkeller

RE: Official XTM X-Cellerator thread!!

I need help with a replacement engine for the stock .18 XTM engine. The XTM engine is rated at 1.3 hp, so im looking for something more powerful. Any small block will be fine and for anyone who can...
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
12-20-2005, 10:54 PM
Replies: 50
Views: 3,958
Posted By WrathSkeller

RE: Project SuperGmaxx

wow that is some hot snit(the n is suppose to be there), good job!
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
12-20-2005, 10:50 PM
Replies: 11
Views: 722
Posted By WrathSkeller

Favorite Brushless

I just want to see some opinions but what are your guys favorite brushless system and why?
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
12-09-2005, 05:50 PM
Replies: 1
Views: 312
Posted By WrathSkeller

Motor Rebuilding

Some quick questions for anyone who can answer:
How do you rebuild a motor completely?
What exactly does a lathe do?
What should I look for in a worn motor?
How does a comm stick work?
...
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
07-26-2005, 04:33 PM
Replies: 14
Views: 753
Posted By WrathSkeller

What Brushless motor do you have?

The subject explains itself. I'm trying to get an idea of the more popular ones. What is a good brushless motor for bashing that won't break the bank??
Showing results 1 to 25 of 204
 
Page 1 of 9
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.