RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: CdnFlyer
Showing results 1 to 17 of 17
Search took 0.70 seconds.
Forum: RC Warbirds and Warplanes
04-07-2014, 09:05 AM
Replies: 40
Views: 5,753
Posted By CdnFlyer

Congratulations Peter, happy you did take the...

Congratulations Peter, happy you did take the Harvard
Forum: Events, Shows and Fun Flys - Airplanes
04-03-2014, 05:52 PM
Replies: 0
Views: 401
Posted By CdnFlyer

Warbirds Over the Bay, 2014, Burlington, Ontario

July 26, 2014 - 2 day(s) -- BURLINGTON RADIO CONTROL MODELERS CLUB INC.



Warbirds Over The Bay - July 26 & 27, 2014

The Burlington Radio Control Modelers will once again be hosting "...
Forum: RC Warbirds and Warplanes
01-12-2014, 06:18 AM
Replies: 40
Views: 5,753
Posted By CdnFlyer

Excellent job Peter, hope to see it at one of the...

Excellent job Peter, hope to see it at one of the meetings soon.

Bill
Forum: RC Warbirds and Warplanes
06-09-2013, 02:25 PM
Replies: 40
Views: 5,753
Posted By CdnFlyer

RE: Yellow Aircraft Harvard Build

Found you Peter, looking forward to some good conversation, and a build on your part
Forum: RC Warbirds and Warplanes
12-19-2012, 06:44 PM
Replies: 296
Views: 58,471
Posted By CdnFlyer

RE: Byron/Iron Bay F4U Corsair build

Hey Grizzie, I just saw your post on Facebook, so naturally had to investigate. The way you are progressing, and when you get the new cores, that airframe should be ready for our Warbirds over the...
Forum: RC Warbirds and Warplanes
08-26-2012, 04:49 PM
Replies: 75
Views: 14,440
Posted By CdnFlyer

RE: That nasty AT-6 Bounce

Ron, the one landing that I saw with a bounce of about 2 - 3 inches was really insignificant. The plane, after the wheels touched the runway, was essentially running on the mains with the tail up,...
Forum: RC Warbirds and Warplanes
08-19-2012, 07:56 PM
Replies: 75
Views: 14,440
Posted By CdnFlyer

RE: That nasty AT-6 Bounce

Will not be down until Friday, and coming alone for the weekend. Will be sleeping in my van. Heading out for dinner on the Friday night to J&D's or J&P's on Route 16 at the end of the road with...
Forum: RC Warbirds and Warplanes
08-17-2012, 06:14 AM
Replies: 75
Views: 14,440
Posted By CdnFlyer

RE: That nasty AT-6 Bounce

Hey Ronnie, am looking forward to seeing it fly in another week. I think I am coming down alone, so I expect you will have coffee on the stove for Saturday and Sunday morning????
Forum: RC Warbirds and Warplanes
08-14-2012, 06:16 PM
Replies: 75
Views: 14,440
Posted By CdnFlyer

RE: That nasty AT-6 Bounce

Ron, sent you an email with a link and picture of how the gear appears to be coming straight down from the wing. You look and decide. Max flap on the T-6 is 45 degrees, so 50 degress is no show...
Forum: RC Warbirds and Warplanes
08-13-2012, 06:02 PM
Replies: 75
Views: 14,440
Posted By CdnFlyer

RE: That nasty AT-6 Bounce

Hey Ron, I used to have a Harvard (Canadian), and wheel landings were mandatory. If the tail dropped too soon, then the angle of attack of the wing would make the beast fly again, but without...
Forum: RC Warbirds and Warplanes
12-25-2011, 11:30 AM
Replies: 21
Views: 1,461
Posted By CdnFlyer

RE: Merry Christmas

Merry Christmas to ALL
Forum: RC Warbirds and Warplanes
12-18-2011, 07:26 PM
Replies: 283
Views: 51,836
Posted By CdnFlyer

RE: ESM Mitsubishi J2M3 Raiden build

I did not know that Pica had a Raiden, but the plans were from an old magazine, I even forget which one. You probably noticed that the fuselage is slab sided instead rotund like yours. Mine has a...
Forum: RC Warbirds and Warplanes
12-18-2011, 07:03 PM
Replies: 283
Views: 51,836
Posted By CdnFlyer

RE: ESM Mitsubishi J2M3 Raiden build

Hi Sessholvlaru: I have been following your build with interest. This is one aircraft that I have admired for some time and it does fly well, at least the one the I have. I built mine from...
Forum: ARF or RTF
09-18-2011, 04:51 PM
Replies: 115
Views: 8,749
Posted By CdnFlyer

RE: What do the ARF guys do in winter?

I am not usually an ARF assembler, but have done a couple, but normally I like to kit build and plan build, so that keeps me busy, as well as repair the summer carnage. I also make myself a real...
Forum: Tips & Techniques
11-16-2010, 10:00 PM
Replies: 220
Views: 42,778
Posted By CdnFlyer

RE: The Pepsi Challenge for Covering Balsa with LS

Another question regarding the products. All the tests so far have been done on flat panels, lying on a flat surface. If one is to paint this onto a fuselage, will there be any run down the sides...
Forum: Tips & Techniques
11-15-2010, 12:45 PM
Replies: 220
Views: 42,778
Posted By CdnFlyer

RE: The Pepsi Challenge for Covering Balsa with LS

Finally, the last two posts get to the point. The thread was originally started to see if the product was 'worth it's weight', no pun intended, but how well it works, and that is the outcome that we...
Forum: RC Jets
08-04-2010, 04:33 PM
Replies: 54
Views: 5,713
Posted By CdnFlyer

RE: What temperatures do you guys fly in?

I live in the sunny tropics part of Canada, where we have had temp ranges from +38 C to -28 C

Nothing like a bright sunny, no wind day with 1 meter snow on the ground, and clear blue sky at...
Showing results 1 to 17 of 17


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.