RCU Forums - Search Results

Search: Posts Made By: TheSteve

Showing results 1 to 7 of 7
Search took 0.35 seconds.

Forum: RC Radios, Transmitters, Receivers, Servos, gyros

06-13-2008, 06:33 PM

Replies: 10

6000 RX with different TX's

Views: 1,027

Posted By TheSteve

RE: 6000 RX with different TX's

The DSM2 receivers transmit back during binding, the AR6000(DSM) doesn't.

I don't think there is any technical reason the DSM2 modules can't communicate with a DSM receiver, I suspect it was...

Forum: Futaba Radios Direct support forum

02-17-2008, 10:24 PM

Replies: 23

R6014FS and hitec servos. Does it work?

Views: 2,097

Posted By TheSteve

RE: R6014FS and hitec servos. Does it work?

The servos will still run at the battery or BEC voltage, its only the signal from the receiver to the servo that tells the servo where to position itself that is running at a lower voltage. It the...

Forum: Futaba Radios Direct support forum

02-17-2008, 07:01 PM

Replies: 23

R6014FS and hitec servos. Does it work?

Views: 2,097

Posted By TheSteve

RE: R6014FS and hitec servos. Does it work?

This isn't the only receiver Futaba has made that has a very low voltage servo drive output. The original R113IP 3 channel PCM ground based receiver also has a very low output on its servo drive. Low...

Forum: Airtronics Support Forum

02-12-2008, 02:12 AM

Replies: 2,617

*Airtronics RD8000 2.4 GHz*

Views: 364,477

Posted By TheSteve

RE: *Airtronics RD8000 2.4 GHz*

I've tried google and a search on this forum without success - can someone post the FCC ID of the RDS8000?
I toured the FCC website but there is no entry for the RDS8000 specifically under the...

Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service

02-08-2008, 05:08 PM

Replies: 4

Hitec servos with a DX3r radio

Views: 1,248

Posted By TheSteve

RE: Hitec servos with a DX3r radio

Mike,

The DX3R comes from the factory with a 91hz frame rate. This appears to be too much for several Hitec servos(and some servos from other companies as well) The solution is as the original...

Forum: RC Radios, Transmitters, Receivers, Servos, gyros

02-07-2008, 02:49 AM

Replies: 1

DX3r ajnd HS-65mg Servos

Views: 673

Posted By TheSteve

RE: DX3r ajnd HS-65mg Servos

Many Hitec servos perform very poorly with a frame rate thats too fast - the DX3R happens to default to one thats too fast for the Hitec servos.
Go into the frame rate menu and change it to the...

Forum: JR Radio & Spektrum Radios

01-17-2008, 01:34 PM

Replies: 60

Spektrum Receiver new "Quick Connect" feature

Views: 11,419

Posted By TheSteve

RE: Spektrum Receiver new "Quick Connect" feature

I finally received my x9303 yesterday. It was easy to confirm the R921 has the quick connect feature. I did a quick power cycle and the receiver LEDs all did the slower flash. Control to the servos...

Showing results 1 to 7 of 7