RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: patnchris
Showing results 1 to 25 of 500
Search took 0.82 seconds.
Forum: Electric Aerobatic & Sport Planes
12-11-2010, 08:50 AM
Replies: 3
Views: 1,143
Posted By patnchris

RE: Second Sport Plane Recommendation

I'll bet the Hanger 9 Pulse XT 46 would work out well with your equipment.
Forum: Electric General Discussion
12-10-2010, 03:57 PM
Replies: 11
Views: 1,209
Posted By patnchris

RE: Charging with triton

I have that charger and was disappointed. Unless I'm mistaken, it doesn't have enough capacity to charge a 6S pack much over 2.5 amps. When charging my 5S packs it will only put out a max of 2.8...
Forum: Electric Pattern Aircraft
11-29-2010, 12:28 PM
Replies: 80
Views: 12,200
Posted By patnchris

RE: Hobby king lipoly batteries

Not sure why some of you have so many problems with Hobby King. I have placed at least 20 orders with them over the past 2 years. I've purchased motors, ESC's, and numerous other parts from them and...
Forum: Electric Aerobatic & Sport Planes
11-11-2010, 11:58 AM
Replies: 3
Views: 1,159
Posted By patnchris

RE: New prop and spinner for Pulse XT40

I thought I might post another tidbit of info, I've found to be true, over the years.
A while back I was flying a newly built plane with a power system that was kindda borderline. After test...
Forum: Electric Aerobatic & Sport Planes
11-11-2010, 11:46 AM
Replies: 3
Views: 1,159
Posted By patnchris

RE: New prop and spinner for Pulse XT40

You actually fly that thing with that little prop?.....Have you ever put a watt meter on it to see where you are?. I have the very same plane with the same motor and speed controller. I've been...
Forum: E-Flight Power Sources
09-19-2010, 04:19 PM
Replies: 6
Views: 1,387
Posted By patnchris

RE: Is this cell dead in a tunigy lipo back?

I had a pack or two that had a bad solder joint on one of the leads to the balance tap.
Forum: 3D Electric Flying!
09-17-2010, 08:11 PM
Replies: 5
Views: 1,154
Posted By patnchris

RE: I need a 42

Agree with the AJ SLick.....3D Hobby Shop makes the best.....Another to look at would be the Extreme Flight Extra...
Forum: Electric Aerobatic & Sport Planes
09-02-2010, 03:31 PM
Replies: 7
Views: 1,407
Posted By patnchris

RE: What did you start with ?

I started with a HobbyZone Super Cub.....It pretty much flys itself. Once I got serious I destroyed 3 Mini Ultra Stiks in as many flights.....After that I actually fles a Mini Pu...Then another Mini...
Forum: Electric Aerobatic & Sport Planes
08-17-2010, 07:06 PM
Replies: 1,963
Views: 319,589
Posted By patnchris

RE: E-Flite Mini Pulse XT Owner's Club

I have been flying my Mini Pulse with an E-Flight Park 450 for 4 years. My flying buddy also has one with a Park 450. The planes fly beautifully on this a combo, using a 2100 ma 3S 15C lipo. I've...
Forum: 3D Electric Flying!
08-17-2010, 06:45 PM
Replies: 3
Views: 1,061
Posted By patnchris

RE: E-Flite S-75 Servo problem

I have used many E-Flight S-75 servos over the past 5 years. I have stripped a few and had a few go wacky, but for the most part, they are pretty good. I would say just scrap that one and get another.
Forum: JR Radio & Spektrum Radios
07-30-2010, 04:00 PM
Replies: 4
Views: 4,200
Posted By patnchris

RE: AR500 blinking light

So, in other words....it's normal????.....That seems a little strange.....How does the RX know the difference if I flipped a switch or just unplugged the battery.....Unless you are saying that it...
Forum: JR Radio & Spektrum Radios
07-30-2010, 03:11 PM
Replies: 4
Views: 4,200
Posted By patnchris

AR500 blinking light

I am new to Spektrum radios, so if this has been asked, before, forgive me.
I recently purchased a DX7 and 2 AR500 RX's. I went through the setup in two planes. The first one, I did a few weeks...
Forum: E-Flight Power Sources
07-27-2010, 03:19 PM
Replies: 3
Views: 988
Posted By patnchris

Hobby City battery packs

I am curious....To all the Hobby City lipo users, out there. Of the three labels, (Zippy, Turnigy, Rhino) which seems to be the best as far as the discharge rates being what they say they are...
Forum: Electric Training
06-17-2010, 05:54 PM
Replies: 23
Views: 4,606
Posted By patnchris

RE: Are you a member of a club?

I started flying about 5 summers ago, with a Firebird Freedom. Moved up to a HobbyZone Super Cub and a couple of GWS foamies. All this was done solo in parks, soccer fields, etc., until I bought my...
Forum: Electric Training
05-27-2010, 11:00 PM
Replies: 7
Views: 2,178
Posted By patnchris

RE: BEC Question

Switch mode BEC's can usually handle a higher input voltage as they generate less heat. However, they are still limited, in the voltage they can handle, by the internal components.

Before you...
Forum: Electric Training
05-26-2010, 04:45 PM
Replies: 7
Views: 2,178
Posted By patnchris

RE: BEC Question

The built in voltge regulator in most ESC's is designed to provide the proper voltage to the reciever to power it and the servo's. The internal circuitry is designed to function at a maximum of 14...
Forum: Park Flyers & Backyard Flyers
05-18-2010, 04:00 PM
Replies: 3
Views: 806
Posted By patnchris

RE: backyard flyer for a Park 400 outrunner

Most of the GWS foamies work well with the Park 400. I had a GWS Tiger Moth 400 and a GWS E-Starter built with that power system and it was dynamite
Forum: Brushed/Brushless motors, speed controls, gear drives
05-13-2010, 06:05 PM
Replies: 2
Views: 747
Posted By patnchris

RE: BEC voltage output?

I used that ESC in my E-Flight Texan. According to the instructions, a separate RX battery was not required. I was running two servo's for the ailerons, two for the flaps, one for the retracts, one...
Forum: Brushed/Brushless motors, speed controls, gear drives
05-13-2010, 05:49 PM
Replies: 4
Views: 751
Posted By patnchris

RE: Hot Motor

To give a logical answer, a lot more information is needed....What Plane, what power system, what prop, etc.
Forum: 3D Electric Flying!
03-29-2010, 09:20 PM
Replies: 42
Views: 4,136
Posted By patnchris

RE: Yak 54 suggestions

I would use the Monster Power 25 that Nitroplanes sells. It's good for 500+ watts and would be good on 4S. Or you could go light and use the MonsterPower 15 on 3S....It will crank 425 watts....That...
Forum: Electric General Discussion
12-12-2009, 03:07 PM
Replies: 3
Views: 707
Posted By patnchris

RE: What size props

Hard to say, exactly, but I'm thinking about a 10X7 APC thin electric or maybe even an 11 X 6.5 APC thin electric. I run a 12 X 6 on mine, but I pull the whole 375 watts on mine.....You're looking at...
Forum: Electric Aerobatic & Sport Planes
12-11-2009, 06:27 PM
Replies: 411
Views: 80,879
Posted By patnchris

RE: Mini Ultra Stick

For those using the higher KV motors I would suggest using a 10 X 5 APC. The 10 X 7 is taxing the Park 450 as it is and if you run it wide open will definately warm the motor. I tried an AXI, a while...
Forum: Electric Aerobatic & Sport Planes
12-11-2009, 06:22 PM
Replies: 411
Views: 80,879
Posted By patnchris

RE: Mini Ultra Stick

And no complaining from the wife about the smell in the garage and on clothes. I personally don'tg mind the smell of glow fuel, but the wife would have them in a storage shed as far from the house as...
Forum: Park Flyers & Backyard Flyers
12-11-2009, 12:18 PM
Replies: 11,777
Views: 2,376,042
Posted By patnchris

RE: Official Hobby Zone

The Dubro parkflyer skis are made from injection molded plastic. It becomes more brittle as the temps drop. As long as the snow is light and fluffy, it is not a problem. However, the snow needs to be...
Forum: Electric Training
12-09-2009, 06:37 PM
Replies: 13
Views: 4,354
Posted By patnchris

RE: What is the slowest, most forgiving electric park trainer

I would stay with GWS but the E-Starter is the way to go for a beginner. Not only will it fly slow, but it is very forgiving. It can be purchased w/brushed motor and gearbox for around the same price...
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.