RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: Mr Electric
Showing results 1 to 24 of 24
Search took 0.40 seconds.
11-12-2010, 08:27 AM
Replies: 1
Views: 645
Posted By Mr Electric

FUTABA RX aerial wire 2.4ghz Replacement

can anyone tell me where in the UK i can get the Futaba Replacement 2.4ghz RX aerial wires from (cheaper the better)

Regs
05-06-2010, 12:37 PM
Replies: 2
Views: 944
Posted By Mr Electric

edf info help

HI and thanks for taking the time to read my post

im going to convert an AMD Hawk to EDF

what i need to no about is the inlet ducting

1st the ducting size is about 95/100mm total
i...
06-06-2008, 01:44 PM
Replies: 5
Views: 1,331
Posted By Mr Electric

RE: u-can-do 60

i did one 6 month ago

i used an AXI 5320/28 = 9cells 4000mah 18x8 wood prop (ic) 36amps

i just strapped the battery packs under the landing gear..

i 1st use a 91 2stroke...

much...
06-06-2008, 01:36 PM
Replies: 1
Views: 667
Posted By Mr Electric

can you restore a squashed foamie "twinjet"

hi..

is there anyway of restoreing a twinjet nose..

its not broken jet a little squashed and bent [:-]

thx all...
Replies: 0
Views: 629
Posted By Mr Electric

oh no not another 2.4ghz problem ??

oh no not another 2.4ghz problem...

well NO ! i have now had my spektrun DX7 set for 6 months (UK)[&o]...
i use AR 7000 , 6200's , 6100,
just make sure you use a good esc bec or a good rx...
01-03-2008, 11:54 AM
01-03-2008, 09:24 AM
Replies: 29
Views: 17,932
Posted By Mr Electric

RE: ELectric Twin Engine Setup

well i disabled both because they dont supply the rx with power anyway
no i dont have a diffrent esc
i just tryed it again and it will still run both as per drawing !!(only ran very slowly to...
01-03-2008, 06:02 AM
Replies: 29
Views: 17,932
Posted By Mr Electric

RE: ELectric Twin Engine Setup

i was amazed too the drawing it correct it runs both motors

but i dont want to run them to fast because it must be getting the negative through the servo lead and that will melt if i turn it up
01-03-2008, 05:59 AM
Replies: 29
Views: 17,932
Posted By Mr Electric

RE: ELectric Twin Engine Setup

the setup is is

axi 4130/16 with master air 12x6 3 bladed pulling about 17.5 amp (about 770 watts)
im waiting for 2 APC-e 13x10 2 bladed should do about 28 amps (about 1170 watts)

...
01-03-2008, 05:54 AM
Replies: 29
Views: 17,932
Posted By Mr Electric

RE: ELectric Twin Engine Setup

ok i have calmed down a little now and the PC is still in 1 peace ;)

the drawing is right ..the broken blue wire is not a switch its just there to show that the system still runs without the...
01-03-2008, 05:12 AM
Replies: 29
Views: 17,932
Posted By Mr Electric

RE: ELectric Twin Engine Setup

this is the very short version
drawing rite blue wire not a switch both motors do run
battery big enough
must get the neg feed from servo wire not reds left in esc 's
the end
01-03-2008, 05:10 AM
Replies: 29
Views: 17,932
Posted By Mr Electric

RE: ELectric Twin Engine Setup

t88t fk fk fk [:@][:@][:@][:@]
i just spent an age writing a reason and lost it all when it timed out

...
01-02-2008, 06:02 PM
Replies: 29
Views: 17,932
Posted By Mr Electric

RE: ELectric Twin Engine Setup

hi
i could do with some help with my twin

http://homepage.ntlworld.com/dale57/a/Phone-0038.jpg

85" mitchell
2 x AXI 4130/16 's
2 x 70 amp opto esc's
Y lead to rx
please look at...
01-02-2008, 05:40 PM
Replies: 4
Views: 1,290
Posted By Mr Electric

RE: YT B-25 MITCHELL

update almost ready :D:D:D
http://homepage.ntlworld.com/dale57/a/Phone-0038.jpg
12-11-2007, 01:57 PM
Replies: 4
Views: 1,290
Posted By Mr Electric

RE: YT B-25 MITCHELL

hi ..sounded a good idea but i will be mounting the motors with the radial mount system
12-11-2007, 12:59 PM
Replies: 0
Views: 638
Posted By Mr Electric

CM-PRO CORSAIR 75.5 WING

i this i the cm pro corsair 120 converted to electric

i use the AXI 5320/28 GOLD LINE

running on 9 cell lipo's

prop was 18x8 wood master airscrew

i maidened it sunday it was a...
12-11-2007, 12:49 PM
Replies: 4
Views: 1,290
Posted By Mr Electric

YT B-25 MITCHELL

I all hope i can list this here because its going to be electric

i got it from ebay last week

the plane,air retracts,wheels,2 hs 81 in the rudders,and more.. all for £100 :D:D

im...
11-13-2007, 02:12 PM
Replies: 4
Views: 842
Posted By Mr Electric

RE: help with this petrol engine make and cc

hi hrrcflyer

the prop is just 1 i put on to try the engine 18 x 6 classic master (full throttle 7200 rpm)

i have been told its a 25cc ????.

and yes its great planes stearman

but...
11-12-2007, 04:17 PM
Replies: 4
Views: 842
Posted By Mr Electric

help with this petrol engine make and cc

hi all

im looking to find out anything about this engine

thx for looking
11-06-2007, 03:07 PM
Replies: 3
Views: 705
Posted By Mr Electric

RE: Spectrum vs NGK spark plug !!!

can you tell me how i would know if its a resistor plug or not ??

thx
11-06-2007, 02:49 PM
Replies: 3
Views: 705
Posted By Mr Electric

Spectrum vs NGK spark plug !!!

:( omg... i have a 26 cc petrol engine in a bi-plane using spectrum DX-7 just changed the spark plug from a champion
plug to a NGK . and every time i turn the engine over it locks out (every single...
10-28-2007, 04:51 PM
Replies: 1,240
Views: 204,894
Posted By Mr Electric

RE: CMPro F4u Corsair

this is mine

just finished well almost [&:]

will i need to had weight upfront

setup is Sc 120 FS

the rest standard
10-28-2007, 01:42 PM
Replies: 17
Views: 2,732
Posted By Mr Electric

RE: Biggest Corsair ARF?

this is mine ..i going to convert it to electric very soon

does any 1 no if it been done ?

thx
Replies: 24
Views: 2,193
Posted By Mr Electric

RE: DX7 users...

Hi my 1st post

im just woundering the same thing [&:] about voltage ..

how can i run 5 standard servos(wing 4) + throttle
2 high toque (ele.rud.)

used in a super...
Showing results 1 to 24 of 24


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.